PART	COLOR	LOCATION
12 VOLT CONSTANT	RED/BLACK (+)	@ BCM, C3, Pin D1, See NOTE *2
STARTER	YELLOW (+) or PURPLE/WHITE (+) (NOT REQUIRED FOR REMOTE STARTING)	@ PCM, BLUE Plug, Pin 48 or 23, See NOTE *7
STARTER 2	N/A
IGNITION 1	PINK (+) See NOTE *6	@ BACK of IGNITION SWITCH, See NOTE *2
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BROWN (+) See NOTE *6 See DIAGRAM	@ BACK of IGNITION SWITCH, See NOTE *2
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BROWN/WHITE (-)	@ BCM, Plug C2, Pin 5, See NOTE *2
PARKING LIGHTS ( + )	BROWN (+)	@ BCM. Plug C3, Pin A7, See NOTE *2
POWER LOCK	WHITE (1-Wire System) See NOTE *5	@ BCM. Plug C1, Pin 66, See NOTE *2
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE *3	@ BCM, C1, See NOTE *2
DOMELIGHT SUPERVISION	GRAY (-)	@ BCM, Plug C3, Pin A10, See NOTE *2
TRUNK RELEASE	BLACK/WHITE (-)	@ BCM, Plug C1, Pin 71, See NOTE *2
SLIDING POWER DOOR	N/A
HORN	TAN (-)	@ BCM, Plug C2, Pin 14, See NOTE *2
TACH	See NOTE *4	@ IGNITION CONTROL MODULE
WAIT TO START LIGHT
BRAKE	WHITE (+)	@ BCM, C1, Pin 24, See NOTE *2
FACTORY ALARM DISARM	DISARMS WITH FACTORY REMOTE CONTROL ONLY
ANTI-THEFT	GM's PASSKEY 3 (PK3 on Steel Shaft of Ignition Key) TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 To gain access to the IGNITION SWITCH HARNESS it will be necessary to remove the RADIO. When doing so, DO NOT UNPLUG RADIO HARNESS. ALL IGNITION wires MUST BE TIED INTO at the BACK of the IGNITION SWITCH ONLY. NOTE *2 The BCM (Body Control Module) is part of the FUSE/RELAY BOX on the FRONT PASSENGER side of the CENTER CONSOLE. It has the following connectors: C1 is a 72-pin BLUE Plug, C2 is a 72-pin GRAY Plug, C3 is a 41-pin RED Plug and C4 is a 68-pin GRAY Plug. NOTE *3 The GRAY/BLACK (-) at Pin 51 is for the DRIVERS DOOR. The TAN/WHITE (-) at Pin 72 is the PASSENGER DOOR, the LIGHT BLUE/BLACK (-) at Pin 54 is the DRIVERS rear door and the LIGHT GREEN/BLACK (-) at Pin 53 is the PASSENGERS rear door. When connecting to an ALARM SYSTEM use all (4) wires and DIODE ISOLATE. NOTE *4 The ECM (Engine Control Module) is located under the DRIVERS side of DASH and to the LEFT of the STEERING COLUMN. On the 2.2L engine the TACH wire is WHITE or ORANGE. On the 3.5L engine the TACH wire is PURPLE, ORANGE/WHITE or LIGHT BLUE. NOTE *5 This vehicle uses a (1) WIRE door locking system, a Straight (-)Negative will LOCK the doors, a (-)Negative thru a 1500 ohm Resistor will UNLOCK the doors. All doors must be closed for this to function properly. See DIAGRAMS. NOTE *6 it will be necessary to add a ACCESSORY Drop Out Relay and an IGNITION #1 Delay Relay to Remote Start this vehicle, See DIAGRAMS NOTE *7 the PCM (Powertrain Control Module) is located in FRONT of the BATTERY on the DRIVERS SIDE of the VEHICLE.