NOTE #1: this vehicle is equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System, that will
require a 791 bypass module and an extra key for operation or the XK09 Bypass
Module that does not require a key for operation to order go to the INTERFACE
BYPASS MODULE PAGE on this website.
NOTE #2: the PARKING LIGHTS on this vehicleRequire an extra relay part #775 and a (-)
Negative thru a 47 Ohm Resistor, See DIAGRAM
NOTE #3: the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to
Lock and a (+)Positive thru a 620 Ohm resistor to Unlock, some units will also
require 2 extra relays part #775 for the keyless entry feature to work, See
DIAGRAMS. You can also get a INTERFACE BYPASS MODULE the Part # XK09 that will
do this for you without adding extra relays and resistors, these Modules will also do
dome light supervision and trunk pop with nothing needed, to order please go to the
INTERFACE BYPASS MODULE Page on this website
NOTE #4: The BCM (Body Control Module) is located under the left side of the dash, attached
to the JUNCTION BLOCK, the plugs on the BCM face the firewall.
NOTE #5: This vehicle has 4 door trigger wires, the DRIVERS DOOR is a TAN (-) Pin 4, the
PASSENGER DOOR is a TAN/RED, Pin 2, the DRIVERS REAR DOOR is a TAN/RED Pin 1
and the PASSENGERS REAR DOOR is a Pin 10. When connecting to an ALARM SYSTEM
use all 4 wires and DIODE ISOLATE. See DIAGRAM
NOTE #6: the DISARM wire on this vehicle requires a (+)Positive thru a 680 Ohm resistor and
an extra Relay Part #775, to connect, See DIAGRAM
|