PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) or RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE/WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 2	DARK GREEN/RED (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	LIGHT BLUE (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	YELLOW (-) See NOTE *1	@ HEADLIGHT SWITCH, See DIAGRAM
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	@ BACK of JUNCTION BLOCK under dash
POWER LOCK	WHITE/GREEN (1-Wire Door Lock System) See NOTE *2	@ BCM, BLUE Plug, Pin 5, See NOTE *3
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE *4	@ BCM BLUE Plug, See NOTE *3
DOMELIGHT SUPERVISION	YELLOW (-)	@ BCM, TAN Plug, Pin 4, See NOTE *3
TRUNK RELEASE	BLACK/WHITE (+)	@ BCM, GREY Plug, Pin 1, See NOTE *3
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ BCM, GREY Plug, Pin 6, See NOTE *3
TACH	ANY wire that is NOT DARK GREEN/LIGHT GREEN	@ ANY IGNITION COIL or FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (+) See NOTE *5	@ BCM. BLUE Plug, Pin 13, See NOTE *3
ANTI-THEFT	CHRYSLERS SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS on this vehicleRequire an extra relay part #R30-H and a (-)Negative thru a 47 Ohm Resistor, See DIAGRAM NOTE *2 the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to Lock and a (+)Positive thru a 620 Ohm resistor to Unlock, some units will also require 2 extra relays part #R30-H for the keyless entry feature to work, See DIAGRAMS. NOTE *3 The BCM (Body Control Module) is located under the left side of the dash, attached to the JUNCTION BLOCK, the plugs on the BCM face the firewall. NOTE *4 This vehicle has 4 door trigger wires, the DRIVERS DOOR is a TAN (-) Pin 4, the PASSENGER DOOR is a TAN/RED, Pin 2, the DRIVERS REAR DOOR is a TAN/RED Pin 1 and the PASSENGERS REAR DOOR is a Pin 10. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE. See DIAGRAM NOTE *5 the DISARM wire on this vehicle requires a (+)Positive thru a 680 Ohm resistor and an extra Relay Part #R30-H, to connect, See DIAGRAM