PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ BCM, BLUE Plug, Pin A1, See NOTE *1
POWER LOCK	LIGHT BLUE (5 Wire Reverse Polarity) See NOTE *2	@ BCM, PURPLE Plug, Pin A4, See NOTE *1
POWER UNLOCK	WHITE (5 Wire Reverse Polarity) See NOTE *2	@ BCM, PURPLE Plug, Pin A3, See NOTE *1
DOOR TRIGGER	See NOTE *3	@ BCM, See NOTE *1
DOMELIGHT SUPERVISION	WHITE (-)	@ BCM, BROWN Plug, Pin A1, See NOTE *1
TRUNK RELEASE	WHITE/BLACK (-)	@ BCM, BLUE PLug, Pin B4, See NOTE *1
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ BCM, BROWN Plug, Pin B7, See NOTE *1
TACH	WHITE or ORANGE	@ IGNITION CONTROL Module, See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with FACTORY REMOTE ONLY
ANTI-THEFT	YELLOW (+) and BLACK (-) and WHITE (Not Used)	GM's PASSLOCK 2 System, wires are under the Steering Column cover, at the Bottom of the Ignition Switch Tumbler in a BLACK or DARK GRAY Plug

EXTRA INFORMATION

NOTE *1 the BCM (Body Control Module) is located ABOVE the DRIVERS KICK PANEL. NOTE *2 if vehicle is NOT equipped with a FACTORY KEYLESS ENTRY, the Door Locks are a 5 Wire Reverse Polarity with the wires located in each kick panel, you must use the Passenger Switch as the Master Switch. Vehicles with factory keyless are Positive (+) Systems. NOTE *3 this vehicle has a GREEN/BLACK (-) Pin A7 for the DRIVERS DOOR and a LIGHT BLUE (-) Pin A8, for the PASSENGER DOOR(S) these wires are located at the BCM. When connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DIAGRAM NOTE *4 the IGNITION CONTROL MODULE is located on the DRIVERS SIDE TOP of the ENGINE.