PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	RED/WHITE (+) ( with Auto Stick only)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	@ HEADLIGHT SWITCH
POWER LOCK	LIGHT GREEN (1-Wire Door Lock System) See NOTE *1	IN DRIVERS DOOR HARNESS, See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	TAN/BLACK (-) and LIGHT BLUE/ORANGE (-) Use both, See NOTE *2, Requires #R30-H Relay	IN DRIVERS KICK PANEL, HARNESS to REAR of vehicle or at KEYLESS ENTRY MODULE, See NOTE *3
DOMELIGHT SUPERVISION	YELLOW (-), Requires #R30-H Relay	IN DRIVERS KICK PANEL
TRUNK RELEASE	BROWN/LIGHT BLUE (-)	@ TRUNK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ HORN SWITCH or at KEYLESS MODULE
TACH	ANY wire NOT DARK GREEN/ORANGE	@ COIL PACK or FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK
ANTI-THEFT	CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 this vehicle uses a 1-Wire Door Locking system, if vehicle is WITHOUT a FACTORY ALARM SYSTEM, LOCK requires a (-)Negative thru a 1000 Ohm Resistor and UNLOCK is a (-)Negative thru a 250 Ohm Resistor. If vehicle HAS a FACTORY ALARM SYSTEM, ARM/LOCK is a (-)Negative thru a 2700 Ohm Resistor and DISARM/UNLOCK is a (-)Negative thru a 7500 Ohm Resistor, some units will require 2 extra relays part #R30-H, to connect, See DIAGRAM. NOTE *2 the DRIVERS DOOR is a TAN/BLACK (-) and the PASSENGER DOOR is a LIGHT BLUE/ORANGE (-) when connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *3 the KEYLESS ENTRY MODULE is located in the Center of the Dash, remove top of dash to access.