| NOTE *1 Vehicles with AUTOMATIC TEMPERATURE CONTROL will have an extra RED/BROWN (+) 12 VOLT Constant and a 3rd ACCESSORY wire, a DARK BLUE (+) that must be connected.
NOTE *2 this vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a 330 Ohm resistor and UNLOCK requires a (-)Negative thru a 100 Ohm Resistor, some units also require 2 extra relays part #R30-H, to connect, See DIAGRAM
NOTE *3 On vehicles WITHOUT MEMORY SEATS, the wire is in the DRIVERS KICK PANEL at the DOOR HARNESS, in vehicles WITH MEMORY SEATS, the wire is in the DRIVERS DOOR at the Drivers Memory Mirror Module.
NOTE *4 On some vehicle if the vehicle REMOTE STARTS and then STOPS and repeats this several times, you may find that it will take up to 1/2 an hour before you can restart with the IGNITION KEY this is a third layer of CHRYSLER SECURITY and you must UNLOCK THE DRIVERS door before remote starting to prevent this from occuring.
NOTE *5 the DRIVERS DOOR is a PURPLE (-), the PASSENGER DOOR is a PURPLE/WHITE, the DRIVERS REAR DOOR is a PURPLE/GREY (-) and the PASSENGER REAR DOOR is a PURPLE/YELLOW (-) The REAR door wires are in a LARGE 74 Pin plug near the FUSEBOX. When connecting to an ALARM SYSTEM use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect See DIAGRAM.
NOTE *6 On vehicles WITHOUT MEMORY SEATS, the FRONT DOOR triggers are in the same plug as the REAR DOORS. WITH MEMORY SEATS, the DRIVERS DOOR trigger is at the Drivers Memory Mirror Module, and the PASSENGER DOOR trigger is at the Passenger Memory Mirror Module in the Passenger door.
NOTE *7 If your vehicle was manufactured before MAY 15, 2004 and you need to have another IGNITION KEY PROGRAMMED to be placed inside the 791 TRANSPONDER BYPASS Module to get around the CHRYSLER SENTRY KEY (GRAY KEY), YOU MUST have this KEY PROGRAMMED by your DODGE DEALER ONLY or the KEY WILL NOT PROGRAM .
NOTE *8 this vehicle has 2 PARKING LIGHT wires that will require 2 extra relays part #R30-H to connect, See DIAGRAM
|
