PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	LIGHT GREEN/WHITE (+) (Use ONLY with AUTO STICK)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	@ HEADLIGHT SWITCH or RKE Module pin 2, See NOTE *1
POWER LOCK	WHITE/DARK GREEN (1-Wire Door Lock System) See NOTE *2	IN DRIVERS KICK PANEL or RKE, PIN 10, See NOTE *1
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE * 3	IN EACH KICK PANEL or RKE Module pins 25 and 7, See DAIGRAM
DOMELIGHT SUPERVISION	YELLOW (-), Requires #R30-H Relay	IN PASSENGER KICK PANEL, Harness to REAR of VEHICLE.
TRUNK RELEASE	BROWN/LIGHT BLUE (-)	@ RKE Module Pin 14, See NOTE *1
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ RKE Module, pin 18, See NOTE *1
TACH	ANY wire NOT DARK GREEN/ORANGE	@ any FUEL-INJECTOR or IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, SINGLE PULSE
ANTI-THEFT	CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the RKE (Remote Keyless Entry) Module is located in the TOP CENTER of the DASH. NOTE *2 This vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a 3000 Ohm Resistor and UNLOCK requires a (-)Negative thru a 7200 Ohm Resistor, and requires a double pulse to UNLOCK. Some units also require 2 extra relays part #R30-H, to connect, See DIAGRAM NOTE *3 This vehicle has 2 Door Trigger wires a TAN (-) or TAN/BLUE (-) in the DRIVERS KICK PANEL for the DRIVERS DOOR and a BLUE/ORANGE (-) in the PASSENGERS KICK PANEL is for all other doors. When using an ALARM SYSTEM use both wires and DIODE ISOLATE. See DIAGRAM