Service: 954-728-9571
Items: 0 - Total: $0.00
See Cart | Check Out
About Us
What's New
Products
Contact Us
Current Specials!
Ordering Information
Our Terms
Shipping Information
Commando and Your Privacy

Search Again?
Need Installation?
Locate An Installer Near You That's Commando Authorized.
Are You An Installer?
Get Listed In our Commando Installer Database and Receive Installation Leads For Free!

Diagrams
Tech Support Home
Ignition & Starter
Starter Kill (3 Wire Harness)
(Download)
-------------------
Starter Kill (5 Wire Harness)
(Download)
-------------------
2nd Starter Wire Relay
(Download)
-------------------
Isolating Starter and Ignition Wires
(Download)
-------------------
Door Locks
Negative Pulse Door Locks
(Download)
-------------------
Positive Pulse Door Locks

(Download)
-------------------

Reverse Polarity Door Locks
(Download)
-------------------
Vacuum Type Door Locks
(Download)
-------------------
Mercedes Vacuum Door Locks
(Download)
-------------------
Toyota Child Safety Locks
(Download)
-------------------
Dodge Caravan Power Locks (Single Wire)

(Download)
-------------------
Ford Probe Door Locks
(Download)
-------------------
Door Lock Actuators
(Download)
-------------------
Trunk & Dome
Trunk Release Configurations
(Download)
-------------------
Domelight Supervision
(Download)
-------------------
Item Links!
Car Alarms
Car Alarm Combos
Alarm Acessories
Remote Car Starters
Keyless Entry
Motorcycle Alarms
Power Windows
Switch Kits
Tailgate Locks
Power Locks
Backup Alarms
Shaved Door Handles
FREE Vehicle Wiring
Diagrams & Charts
Select Your Make


Vehicle Wiring Details for your
2004-2005 Chrysler PT Cruiser Wiring Diagram
Printer Friendly
Version
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2004-2005 Chrysler PT Cruiser . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.

 PART   COLOR  LOCATION
 12 VOLT CONSTANT   PINK/BLACK (+) and RED (+)   IGNITION SWITCH HARNESS
 STARTER  YELLOW (+)  IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  DARK BLUE (+)  IGNITION SWITCH HARNESS
 IGNITION 2  LIGHT GREEN/WHITE (+) (Use ONLY with AUTO STICK)  IGNITION SWITCH HARNESS
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  BLACK/ORANGE (+)  IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  BLACK/WHITE (+)  IGNITION SWITCH HARNESS
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  BLACK/YELLOW (+)  @ HEADLIGHT SWITCH or RKE Module pin 2, See NOTE #2
 POWER LOCK  WHITE/DARK GREEN (1-Wire Door Lock System), See NOTE #3  IN DRIVERS KICK PANEL or RKE, PIN 10, See NOTE #2
 POWER UNLOCK  Same wire, See DIAGRAM  See DIAGRAMS
 DOOR TRIGGER  See NOTE #4  IN EACH KICK PANEL or RKE Module pins 25 and 7, See DAIGRAM
 DOMELIGHT SUPERVISION  YELLOW (-), (Requires #775 Relay)  IN PASSENGER KICK PANEL, Harness to REAR of VEHICLE.
 TRUNK RELEASE  BROWN/LIGHT BLUE (-), (Requires #775 Relay)  @ RKE Module Pin 14, See NOTE #2
 SLIDING POWER DOOR  N/A  
 HORN  BLACK/RED (-)  @ RKE Module, pin 18, See NOTE #2
 TACH  ANY wire NOT DARK GREEN/ORANGE (AC)  @ any FUEL-INJECTOR or IGNITION COIL
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE/TAN (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   DISARMS WITH UNLOCK, SINGLE PULSE  
 ANTI-THEFT  CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: the RKE (Remote Keyless Entry) Module is located in the TOP CENTER of the DASH. NOTE #3: This vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a 3000 Ohm Resistor and UNLOCK requires a (-)Negative thru a 7200 Ohm Resistor, and requires a double pulse to UNLOCK. Some units also require 2 extra relays part #775, to connect, See DIAGRAM. You can also get a INTERFACE BYPASS MODULE the Part # DB-ALL that will do this for you without adding extra relays and resistors, these Modules will also do dome light supervision and trunk pop with nothing needed, to order please go to the INTERFACE BYPASS MODULE Page on this website NOTE #4: This vehicle has 2 Door Trigger wires a TAN (-) or TAN/BLUE (-) in the DRIVERS KICK PANEL for the DRIVERS DOOR and a BLUE/ORANGE (-) in the PASSENGERS KICK PANEL is for all other doors. When using an ALARM SYSTEM use both wires and DIODE ISOLATE. See DIAGRAM
 
Shop By Category!
Security Systems
Keyless Entry
Remote Starters
Power Door Locks
Power Windows
Shaved Door Handles
SPAL Cooling Fans
Solenoids & Actuators
Alarm Sensors
Installation Accessories
Keyword Search
 
Go Search!
Precision Search
Brand Search
View Details... Baretta 2 Way LCD Pager/ Car Alarm Keyless Entry
$99.99

View Details... 4 Door Power Lock Kit with G20 Keyless Entry and Alarm
$94.99

View Details... CrimeStopper RS4 Remote Start and Full Keyless Entry System
$123.99

View Details... Electric Start 13Hp 6500 Watt Portable Gas Generator w/ wheels
$750.00

View Details... Car Alarms w/ LCD 2 Way Pager and Keyless Entry
$89.95

View Details... CrimeStoppers - RS1 1-way Remote Starter and full keyless Entry System
$74.99

View Details... G20-PAC Car Alarm, Keyless Entry w/relay pack
$59.99

View Details... Commando DL-100 Car Alarm, Keyless Entry Upgrade
$59.00

View Details... Avatal 3001L OEM security upgrade
$93.98

View Details... Commando 357 Car Alarm
$45.00