PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE/WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 2	DARK GREEN/RED (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	YELLOW (-) See NOTE *1	@ HEADLIGHT SWITCH or BCM, BLACK Plug, Pin 2, See NOTE *4
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	@ BACK of JUNCTION BLOCK, GRAY Plug, Pin 11
POWER LOCK	WHITE/DARK GREEN (1-Wire Door Lock System) See NOTE *2	@ BCM, BLUE Plug, Pin 5 See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE *3	@ BCM, See NOTE *4
DOMELIGHT SUPERVISION	YELLOW (-), Requires #R30-H Relay	@ FRONT of JUNCTION BLOCK, TAN Plug, Pin 4
TRUNK RELEASE	BLACK/WHITE (+), Requires #R30-H Relay	@ TRUNK RELEASE SWITCH or BCM, GRAY Plug, Pin 1, See NOTE *4
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ BACK of JUNCTION BLOCK, GRAY Plug, Pin 6
TACH	ANY wire NOT DARK GREEN/LIGHT GREEN	@ ANY COIL or FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (-) See NOTE *5	@ BCM, BLUE Plug, Pin 13, See NOTE *4
ANTI-THEFT	CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS require a (-)Negative thru a 47 Ohm Resistor and an extra Relay part #R30-H, to connect, See DIAGRAM. NOTE *2 this vehicle uses a 1-Wire Door Locking System, LOCK requires a (+)Positive thru a 2700 Ohm Resistor and UNLOCK requires a (+)Positive thru a 620 Ohm Resistor, some units will also require 2 extra relays part #R30-H, to connect, See DIAGRAM NOTE *3 the DRIVERS DOOR is a TAN (-) Pin 4, the PASSENGER DOOR is a TAN/RED (-) Pin 2, the DRIVERS REAR DOOR is a TAN/RED (-) Pin 1 and the PASSENGER REAR DOOR is a TAN/RED (-) Pin 10, when connecting to an ALARM SYSTME, use ALL 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *4 the BCM (Body Control Module) is located on the DRIVERS SIDE of the DASH attached to the FUSE/JUNCTION block. NOTE *5 this FACTORY DISARM wire will require an extra relay part #R30-H and a (-)Negative thru a 680 Ohm Resistor, to connect, See DIAGRAM