PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE/WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 2	DARK GREEN/RED (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	YELLOW (-) See NOTE *1	@ HEADLIGHT SWITCH, See DIAGRAM
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	@ BACK of JUNCTION BLOCK, GRAY Plug, Pin 11
POWER LOCK	WHITE/DARK GREEN (1-Wire Door Lock System) See NOTE *1	@ BCM, BLUE Plug, Pin 5, See NOTE *3
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	See NOTE * 5	@ BCM BLUE PLUG, See NOTE *3
DOMELIGHT SUPERVISION	YELLOW (-), Requires #R30-H Relay	@ FRONT of JUNCTION BLOCK, BROWN Plug Pin 4
TRUNK RELEASE	BLACK/WHITE (+), Requires #R30-H Relay	@ TRUNK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ BACK of JUNCTION BLOCK, GRAY Plug, Pin 6
TACH	See NOTE *4	@ IGNITION COIL PACK
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (+) See NOTE *6	@ BCM. BLUE Plug, Pin 13, See NOTE *3
ANTI-THEFT	CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS require an extra relay Part #R30-H and a (-)Negative thru a 47 Ohm Resistor, to connect, See DIAGRAM NOTE *2 the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to LOCK and a (+)Positive thru a 620 Ohm resistor to UNLOCK, some units will also require 2 extra relays part #R30-H for the keyless entry feature to function, See DIAGRAMS. NOTE *3 The BCM (Body Control Module) is located on the LEFT SIDE of the dash attached to the JUNCTION BLACK. NOTE *4 This vehicle uses a Multi-Coil system, for TACH use any wire at the coil pack that is NOT DARK GREEN/LIGHT GREEN NOTE *5 the DRIVERS DOOR is a TAN (-) PIN 4, the PASSENGER DOOR is a TAN/RED (-) PIN 2, the DRIVERS REAR DOOR is a TAN/RED (-) PIN 1 and the PASSENGER REAR DOOR is a TAN/RED (-) PIN 10. When connecting to an ALARM SYSTEM, use all 4 wires and DIODE ISOLATE See DIAGRAM NOTE *6 the DISARM wire requires an extra relay part #R30-H and a (+)Positive thru a 680 Ohm Resistor, to connect, See DIAGRAM.