Vehicle
Wiring Details for your
2003-2009 Porsche Cayenne Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2003-2009 Porsche Cayenne . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) 150 AMP |
@ DRIVERS DASH FUSE BOX |
| STARTER |
RED/BLACK (+) (NOT for REMOTE STARTING), NOTE #1 |
@ STARTER or STARTER RELAY in UNDERHOOD FUSE BOX |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
BLACK (+) (NOT for REMOTE STARTING), NOTE #1 |
@ DRIVERS DASH FUSE BOX |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
GREEN/YELLOW (-) |
@ VESCM, (26-PIN PLUG(A), PIN 17, NOTE #2 |
| PARKING
LIGHTS ( + ) |
BLACK/BLUE(+)(Left Front) and GRAY/RED(+)(Right Front), See NOTE #3 |
@ VESCM, (6-PIN PLUG(C), PIN 4 and (6-PIN PLUG(K), PIN 3, NOTE #2 |
| POWER LOCK |
BROWN/GREEN (-) thru a 780 Ohm Resistor |
@ DRIVERS DOOR MODULE, (GRAY, 32-PIN PLUG), PIN 6 |
| POWER UNLOCK |
Use LOCK wire, straight (-) |
|
| DOOR TRIGGER |
RED/BLUE (-) |
@ DRIVERS DOOR MODULE, (BLACK, 12-PIN PLUG), PIN 2 |
| DOMELIGHT
SUPERVISION |
BLUE/WHITE (-) |
@ VESCM, (16-PIN PLUG(P), PIN 14, NOTE #2 |
| TRUNK RELEASE |
YELLOW/BLUE(-)(Liftgate) and YELLOW(-)(Liftgate Glass), NOTE #5 |
@ COMFORT SYSTEM CONTROL MODULE, (23-PIN PLUG), PINS 12 and 3, NOTE #4 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
PURPLE (+) |
@ VESCM, (4-PIN PLUG(G), PIN 1, NOTE #2 |
| TACH |
NOTE #6 |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BLACK/RED (+) |
@ COMFORT SYSTEM CONTROL MODULE, (23-PIN PLUG), PIN 6, NOTE #4 |
| FACTORY
ALARM DISARM |
BLUE/YELLOW (-) thru a 250 Ohm Resistor, NOTE #7 |
@ DRIVERS DOOR MODULE, (BLACK, 12-PIN PLUG), PIN 8 |
| ANTI-THEFT |
PORSCHE'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: PORSCHE'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
SPECIAL IGNITION CIRCUIT Requires Bypass Module Part # DLPK-CANBUS MULTI for
REMOTE START and KEYLESS ENTRY.
NOTE #2: the VESCM (Vehicle Electronic System Control Module) is located under the DRIVERS DASH, above the GAS PEDAL
NOTE #3: the LEFT REAR PARKING LIGHT and RIGHT REAR PARKING LIGHT is a GRAY/BLACK (+) pin 5 at the COMFORT CONTROL MODULE, in the RIGHT REAR QUARTER PANEL
NOTE #4: the COMFORT CONTROL MODULE, is in the RIGHT REAR QUARTER PANEL
NOTE #5; TEST these wires while Opening the Liftgate and Liftgate Glass with the Handle on the Rear of the Vehicle.
NOTE #6: for the TACH wire use the NON COMMON wire on the V6 and on the V8 use any wire NOT with a RED STRIPE, ALL TEST (AC)
NOTE #7: TEST this wire while turning the KEY in the DRIVERS DOOR. On some models this wire onlu controls the power locks and power windows, it will not control the factory alarm.
|
|
|
|
|
|
