2003-2007 Infiniti G35 Coupe Vehicle Wiring Chart and Diagram

PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/BLUE (+)	@ IGNITION SWITCH HARNESS
STARTER	RED/WHITE (+) or WHITE/RED (+) See NOTE *1	@ IGNITION SWITCH HARNESS
STARTER 2	WHITE/GREEN (+) See NOTE #2	@ IGNITION SWITCH HARNESS
IGNITION 1	BLACK/RED (+)	@ IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	WHITE/BLACK (+)	@ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED/BLUE (+)	in DRIVERS KICK PANEL, HARNESS heading to REAR of Vehicle
POWER LOCK	YELLOW (TYPE B) See NOTE #3	@ DRIVERS DOOR MODULE in DRIVERS DOOR
POWER UNLOCK	LIGHT BLUE (TYPE B) Requires Double Pulse See NOTE #2	@ DRIVERS DOOR MODULE in DRIVERS DOOR
DOOR TRIGGER	YELLOW (-) and PINK (-) Use both, See NOTE #4	@ BCM, WHITE 12 PIN PLUG, See NOTE #5
DOMELIGHT SUPERVISION	TURNS ON with UNLOCK
TRUNK RELEASE	PINK (-)	@ BCM, BROWN PLUG, PIN 76, See NOTE #5
SLIDING POWER DOOR	N/A
HORN	GREEN/BLACK (-)	@ STEERING COLUMN HARNESS
TACH	ANY WIRE NOT BLACK or WHITE/BLUE	@ ANY IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	PINK/BLUE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, Single Pulse Disarms
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES Bypass Module, See NOTE #1	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE #1: This vehicle is equipped with INFINITI'S TRANSPONDER ANTI-THEFT System that requires a Bypass Module for Remote Starting: Part# 791 Bypass Module (Key Required) requires an Extra Ignition Key placed inside module for Operation FOR REMOTE STARTING ONLY!!. Part # XK09 Bypass Module (No Key Require in Module) FOR REMOTE STARTING ONLY!! Part # DB-ALL Interface Bypass Module (No Key Required) this bypass is for Remote Starting and does the door locks (keyless entry), truck release, parking lights and Brake connection. To order go to the INTERFACE BYPASS MODULE Page on this website. NOTE #2: When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE #3: TEST THESE WIRES WHILE TURNING THE KEY IN THE DRIVER DOOR KEY CYLINDER. NOTE #4: THE DRIVERS DOOR IS A YELLOW (-) PIN 14, THE PASSENGER DOOR IS A PINK (-) PIN 10. WHEN CONNECTING TO AN ALARM SYSTEM, USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM NOTE #5: THE BCM (BODY CONTROL MODULE) IS LOCATED IN THE DRIVERS KICK PANEL, THE BCM HAS 4 WHITE PLUGS AND 1 BROWN PLUG.