PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNTION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	RED/BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PURPLE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED/GREEN (+) See NOTE *1	@ HEADLIGHT SWITCH
POWER LOCK	BLACK/WHITE (Negative (-))	@ TWICE Module, Pin 56, See NOTE *2
POWER UNLOCK	YELLOW/BLUE (Negative (-)) (REQUIRES DOUBLE PULSE)	@ TWICE Module, Pin 33, See NOTE *2
DOOR TRIGGER	See NOTE *3	@ TWICE MODULE, See NOTE *2
DOMELIGHT SUPERVISION	RED/GREEN (-)	@ DICE Control Module, Pin 23, See NOTE *4
TRUNK RELEASE	YELLOW (-)	@ TWICE Module, Pin 11, See NOTE *2
SLIDING POWER DOOR	N/A
HORN	BROWN/ORANGE (-)	@ SAAB INFORMATION DISPLAY, Pin 17, See NOTE *5
TACH	RED/BLUE, RED, YELLOW/BLUE, RED/GREEN	@ IGNITION DISCHARGE Module, See NOTE *6
WAIT TO START LIGHT	N/A
BRAKE	GREEN/GREY (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK
ANTI-THEFT	SAAB'S TRANSPONDER, REQUIRES 791 BYPASS and EXTRA IGNITION KEY (Some Vehicles)	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHT wire is a 5-Wire circuit that will require an extra Relay Part #R30-H, to connect, See DIAGRAM NOTE *2 the TWICE Module (theft module) is located UNDER the DRIVERS SEAT. When testing the Lock and Unlock wires, you must test while turning the key in the drivers door key cylinder. NOTE *3 the DRIVERS DOOR is a RED/BLUE (-) Pin 61 and the PASSENGERS DOOR is a GREEN/BLUE (-) Pin 60, the DRIVERS REAR DOOR is a YELLOW/WHITE (-) Pin 12 and the PASSENGERS REAR is a GREEN (-) Pin 36. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DIAGRAM NOTE *4 the DICE Module, is located above the Main relay board under the drivers side of dash. NOTE *5 the SAAB INFORMATION DISPLAY, is located in the Center of the Dashboard, above the Radio. NOTE *6 the IGNITION DISCHARGE Module, is located on the camshaft cover. Use any of these wire.