PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/BLUE (+)	IGNITION SWITCH HARNESS
STARTER	GREEN/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLACK/WHITE (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLUE/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	WHITE/GREEN (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	GREEN/YELLOW (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	GREEN (-)	@ BECU, TOP PLUG PIN 8 See NOTE *5
PARKING LIGHTS ( + )	GREEN (+)	@ 16 PIN PLUG LEFT OF FUSES
POWER LOCK	GREEN/BLACK to BLACK/ORANGE (Negative (-)) SEE NOTE *2	@ GRAY 18-PIN PLUG, IN PASSENGER KICK PANEL
POWER UNLOCK	GREEN (Negative (-)) See NOTE *2	@ GRAY 18-PIN PLUG, IN PASSENGER KICK PANEL
DOOR TRIGGER	See NOTE *3	IN MIDDLE PLUG, @ BECU, See NOTE *6
DOMELIGHT SUPERVISION	WHITE (-), Requires Part #R30-H Relay	@ PIN 8, PLUG TO THE RIGHT OF FUSES
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	GREEN/RED (-)	@ STEERING COLUMN HARNESS
TACH	BLACK/WHITE	IN PIN 5, CONNECTOR E9 @ ECM, See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	GREEN/YELLOW (+)	@ 16-PIN PLUG, LEFT OF FUSES
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire, See NOTE *5	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 WHEN CONNECTING TO A REMOTE STARTER, YOU MUST USE BOTH THE STARTER #1 AND #2 WIRES, CONNECT BOTH TO THE STARTER/CRANK WIRE FROM THE REMOTE STARTER. NOTE *2 METER THESE WIRES WHILE TURNING THE KEY IN THE PASSENGER DOOR KEY CYLINDER. NOTE *3 THE DRIVERS DOOR TRIGGER IS RED/YELLOW (-) IN PIN 23,THE PASSENGER DOOR TRIGGER IS RED/YELLOW (-) IN PIN 24.THE LEFT REAR DOOR TRIGGER IS PINK/BLACK (-) IN PIN 11.AND THE RIGHT REAR DOOR PINK/BLUE (-) PIN 12.USE ALL 4 WIRES AND DIODE ISOLATE EACH.THE BODY ECU IS PART OF THE FUSEBOX UNDER THE DRIVERS SIDE DASH.THE THREE PLUGS ON THE RIGHT SIDE EDGE OF THE FUSEBOX ARE FOR THE BODY ECU. WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 4 DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM NOTE *4 THE ECM (ELECTRONIC CONTROL MODULE) IS LOCATED BEHIND THE GLOVEBOX. NOTE *5 the vehicle can be disarmed without unlocking by attaching a (-) Negative output wire to the GREEN/YELLOW (-) KEYSENSE wire in the IGNITION SWITCH HARNESS. NOTE *6 THE BECU (BODY ELECTRONIC CONTROL MODULE) IS ATTACHED TO THE BACK OF THE FUSEBOX IN DRIVERS KICK PANEL.