PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	GRAY/DARK GREEN (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	GRAY/BLACK (+) and GRAY/RED (+) Use both, See NOTE *1	@ FUSEBOX, BLACK 15 Pin plug, Pins 4 and 6
POWER LOCK	WHITE/YELLOW (Negative (-)) See NOTE *2	@ SWITCH on DASH or CTM, PINK Plug, Pin 7, See NOTE *3
POWER UNLOCK	WHITE/YELLOW (Negative (-)) See NOTE *2	@ SWITCH on DASH or CTM, PINK Plug Pin 7, See NOTE *3
DOOR TRIGGER	BROWN/WHITE (-)	IN DRIVERS DOOR HARNESS
DOMELIGHT SUPERVISION	USE DOOR TRIGGER, Requires Part #R30-H Relay
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	BLACK/YELLOW (-)	@ STEERING COLUMN HARNESS
TACH	DARK GREEN/YELLOW	@ DATA LINK CONNECTOR, Pin 3, See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	BLACK/RED (+)	@ SWITCH ABOVE BRAKE PEDAL, See NOTE *5
FACTORY ALARM DISARM	BLACK (-)	IN DRIVERS KICK PANEL
ANTI-THEFT	CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS are a 2-Wire System and will require 2 extra Relays part #R30-H, to connect, See DIAGRAM NOTE *2 a (-)Negative pulse on this wire will alternate between LOCK and UNLOCK. Use DIODES on the LOCK and UNLOCK outputs from the unit if the unit you are using does not have on board Door Lock Relays and wire in as a Negative (-) tie both wires to this wire in the vehicle. NOTE *3 the CTM (Central Timmer Module) is located under the drivers seat. NOTE *4 the DATA LINK Connector is under the DRIVERS SIDE of DASH. NOTE *5 the BRAKE LIGHT will only test with ignition on.