PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	RED/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLUE (+) or RED/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	If Equipped with DRL See NOTE *2	@ HEADLIGHT SWITCH See DIAGRAM
PARKING LIGHTS ( + )	NOT equipped with DRL See NOTE *2	@ HEADLIGHT SWITCH See DIAGRAM
POWER LOCK	PURPLE/GRAY to BROWN/YELLOW (Negative (-))	@ CENTRAL LOCKING CONTROL MODULE, C3 PIN 12 See NOTE *3
POWER UNLOCK	RED/GRAY ot GREEN/YELLOW (Negative (-)) Requires Double Pulse	@ CENTRAL LOCKING CONTROL MODULE, C3 PIN 6 See NOTE *3
DOOR TRIGGER	See NOTE *4	@ CENTRAL LOCKING CONTROL MODULE C5 PINS 1 and 10 See NOTE *3
DOMELIGHT SUPERVISION	BROWN/WHITE (-)	@ CENTRAL LOCKING CONTROL MODULE C1 PIN 2 See NOTE *3
TRUNK RELEASE	PURPLE/GREEN (5-Wire) See NOTE *5	@ CENTRAL LOCKING CONTROL MODULE, C4 PIN 5 See NOTE *3
SLIDING POWER DOOR	N/A
HORN	BLACK/YELLOW (+)	@ HORN RELAY, UNDER DRIVERS SIDE of DASH
TACH	GREEN/BROWN	@ ECM, PIN 37 See NOTE *6
WAIT TO START LIGHT	N/A
BRAKE	RED/BLACK (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, Single Pulse on UNLOCK wire, Disarms
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 On vehicles with DLR, use the GRAY/YELLOW (+) at the HEADLIGHT SWITCH, use a RELAY to isolate this wire use the DIAGRAM on the (-) PARKING LIGHTS INFO. On vehicles without the DRL, use the GRAY/BROWN and GRAY/PURPLE (+) wires at the HEADLIGHT SWITCH and use the DIAGRAM NOTE *3 The CENTRAL LOCKING CONTROL MODULE is located in the DRIVERS SIDE QUARTER PANEL in front of the FENDERWELL NOTE *4 The DRIVERS DOOR is a BROWN/YELLOW (-) and the PASSENGER DOOR is a BROWN/WHITE (-) both wires are at the CENTRAL LOCKING MODULE, when connecting to an ALARM SYSTEM use BOTH wires and DIODE ISOLATE See DIAGRAM NOTE *5 the TRUNK/HATCH Release system on this vehicle uses a 5-Wire Circuit and will require an extra Relay Part #R30-H to connect, See DIAGRAM NOTE *6 The ECM is located under the PLASTIC COVER on the FIREWALL under the hood.