PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/BLUE (+)	IGNITION SWITCH HARNESS
STARTER	WHITE/RED (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	WHITE/GREEN (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	WHITE/BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	BLACK/PINK (+)
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED/BLUE (+)	IN DRIVERS KICK PANEL
POWER LOCK	RED/WHITE (Negative (-)) See NOTE *3	DRIVER DOOR MODULE IN DOOR TYPE (B) (SEE NOTES)*
POWER UNLOCK	BLUE/WHITE (Negative (-)) Requires Double Pulse See NOTE *3	DRIVER DOOR MODULE IN DOOR TYPE (B) (SEE NOTES) **
DOOR TRIGGER	See NOTE * 4	@ BCM, WHITE 12 PIN PLUG, See NOTE *2
DOMELIGHT SUPERVISION	USE DOOR TRIGGER
TRUNK RELEASE	BLUE (-)	@ BCM, BROWN PLUG, PIN 76, See NOTE *2
SLIDING POWER DOOR	N/A
HORN	GREEN/BLACK (-)	@ STEERING COLUMN HARNESS
TACH	ANY WIRE NOT BLACK OR WHITE/BLUE (-)	@ ANY IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	PINK/BLUE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, Single Pulse Disarms
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 BCM (BODY CONTROL MODULE ) IS IN DRIVER KICK PANEL NOTE *3 TEST THESE WIRES WHILE TURNING THE KEY IN THE DRIVER DOOR KEY CYLINDER, UNLOCK REQUIRES A DOUBLE PULSE FROM THE UNIT. NOTE *4 DRIVER DOOR TRIGGER IS WHITE (-) WIRE IN PIN 14 , FRONT PASSENGER DOOR WIRE IS PINK (-) IN PIN 10, THE REAR DOOR TRIGGER ( ON VEHICLE WITHOUT NAVIGATION ) PINK WIRE IN PIN 11 .ON VEHICLES WITH NAVIGATION SYSTEM THE REAR DOOR TIGGER ARE TWO SEPARTE PINK (-) WIRES IN THE DRIVER KICK PANEL IN THE HARNESS THAT RUNS TO THE REAR .USE ALL WIRES AND DIODE ISOLATE EACH SEE DIAGRAM