PART	COLOR	LOCATION
12 VOLT CONSTANT	(2) RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	WHITE (+) See NOTE *5	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	LIGHT GREEN (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	GRAY/BLACK (-)	@ BCM, BROWN Plug, Pin B2, See NOTE *2
PARKING LIGHTS ( + )	BROWN (+)	IN DRIVERS KICK PANEL
POWER LOCK	See NOTE *1
POWER UNLOCK	See NOTE *1
DOOR TRIGGER	See NOTE *3	See DIAGRAM
DOMELIGHT SUPERVISION	GRAY/BLACK (-)	See NOTE *3
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	BLACK (-) or BLACK/YELLOW (-)	@ STEERING COLUMN or GRAY PLUG @ BCM *4
TACH	WHITE	@ PCM, See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN (-)	@ DRIVER DOOR MODULE in DRIVERS DOOR.
ANTI-THEFT	YELLOW (+), BLACK (-) and RED/WHITE (Not Used)	GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column.

EXTRA INFORMATION

NOTE *1 This vehicle will Requires a Anti-Theft Bypass Module Part GMDL-BP to connect the Door Locks and Bypass the PASSLOCK 2 System. If not connecting up the Door locks use the 791 Bypass module. NOTE *2 The BCM (Body Control Module) is located behind the drivers side of the dash, with the plugs facing the rear of the vehicle. NOTE *3 This vehicle use (2) door pin triggers, the DRIVERS DOOR is a GRAY/BLACK (-) at the DRIVERS DOOR module in the DRIVERS DOOR. The PASSENGER DOOR is a BLACK/WHITE (-) at the PASSENGERS DOOR module in the PASSENGERS DOOR. The DRIVERS REAR DOOR is a LIGHT BLUE/BLACK (-) Pin A3 and the PASSENGERS REAR DOOR is a LIGHT GREEN/BLACK (-) Pin A2, both are located at the BCM, PURPLE plug. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE, See DIAGRAM NOTE *4 The PCM (Power Control Module) is located in the LEFT front of the engine compartment to the LEFT of the fan shroud. The TACH wire is in a GREEN Plug Pin 10. NOTE *5 IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!!