PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/RED (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLUE/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	PINK/BLACK (+) and GREEN/WHITE (+) Use both, See NOTE *1	IN DRIVERS KICK PANEL, 38 Pin plug, pins 26 and 27
POWER LOCK	PURPLE (Negative (-))	IN DRIVERS KICK PANEL
POWER UNLOCK	LIGHT GREEN/RED (Negative (-))	IN DRIVERS KICK PANEL
DOOR TRIGGER	LIGHT GREEN (-) and LIGHT GREEN/BLACK (-) use both, See DIAGRAM	See NOTE *2
DOMELIGHT SUPERVISION	GREEN/ORANGE (-), Requires Part #R30-H Relay	TOP of FUSEBOX, 3 Pin plug
TRUNK RELEASE	GREEN/WHITE (5-Wire) See NOTE *4, Requires Part #R30-H Relay	@ ETACS ECU Pin 32, See NOTE *3
SLIDING POWER DOOR	N/A
HORN	LIGHT GREEN/BLACK (-)	@ ETACS ECU Pin 44, See NOTE *3
TACH	WHITE	@ ENGINE SPEED DETECTION CONNECTOR, See NOTE *5
WAIT TO START LIGHT	N/A
BRAKE	GREEN/ORANGE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	ORANGE (-)	@ ETACS Module pin 25, See NOTE *3
ANTI-THEFT	CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS on this vehicle use a 2-Wire System that will require 2 extra Relays part # R30-H, to connect, See DIAGRAM NOTE *2 the Drivers doors LIGHT GREEN (-) is at the TOP of the FUSEBOX in a 15pin plug, pin 6 and the Passengers door LIGHT GREEN/BLACK (-) is at the ETACS ECU, Pin 65. when connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DIAGRAM NOTE *3 the ETACS ECU is attached to the back of the fusebox at the far end of the DRIVERS SIDE DASH. NOTE *4 the TRUNK RELASE on this vehicle is a 5-Wire System that will require an extra Relay part #R30-H, to connect See DIAGRAM. NOTE *5 this connector is a Single Pin plug in the FUSE/RELAY box under the hood.