NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.
NOTE *2 the BCM (Body Control Module) is located in the DRIVERS KICK PANEL
NOTE *3 you must test these wires while turning the key in the Drivers door key cylinder.
NOTE *4 the DRIVERS DOOR is a RED/YELLOW (-) Pin 142, the PASSENGER DOOR is a LIGHT GREEN (-) Pin 37, the DRIVERS REAR DOOR is a WHITE (-) Pin 33 and the PASSENGERS REAR DOOR is a WHITE/BLUE (-) Pin 143 all are at the BCM. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM
|