PART	COLOR	LOCATION
12 VOLT CONSTANT	RED/WHITE (+)	IGNTION SWITCH HARNESS
STARTER	BROWN/WHITE (-) (Not required for Remote Starting)	@ ECM, Drivers side Connector Pin 58, See NOTE *1
STARTER 2	N/A
IGNITION 1	RED/BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLUE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BROWN/YELLOW (-)	@ HEADLIGHT SWITCH
PARKING LIGHTS ( + )	DO NOT USE!
POWER LOCK	GREEN (4-Door) YELLOW (CV)	@ CENTRAL LOCK SWITCH IN DRIVERS DOOR, See NOTE *2
POWER UNLOCK	Same wire, See NOTE *2	See NOTE *2
DOOR TRIGGER	See NOTE *3	@ BCM, See NOTE *4
DOMELIGHT SUPERVISION	See NOTE *3	@ BCM, See NOTE *4
TRUNK RELEASE	GREEN/WHITE to BROWN/RED (-)	@ BCM, Pin B58, See NOTE *4
SLIDING POWER DOOR	N/A
HORN	BLUE/WHITE (-)	@ COLUMN INTEGRATION MODULE, See NOTE *5
TACH	NOT RED, RED/YELLOW or BLACK	@ ANY FUEL-INJECTOR or IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	RED/GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with FACTORY REMOTE ONLY
ANTI-THEFT	SAAB'S TRANSPONDER, REQUIRES 791 BYPASS and EXTRA IGNITION KEY (Some Vehicles)	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the ECM (Electronic Control Module) is located on the FRONT PASSENGER side of the ENGINE. NOTE *2 this vehicle uses a 1-Wire DOOR LOCKING SYSTEM, the Resistor values are not known at this time, you can check these values by cutting the wire and metering the switch side of this wire by holding the switch to get the values. NOTE *3 the DRIVERS DOOR is a GREEN to GREY (-) at Pin A12, the PASSENGER DOOR is a GREEN to ORANGE/BLUE (-) Pin A11, the DRIVERS REAR DOOR is a PURPLE to BROWN/ORANGE (-) Pin A10, the PASSENGER REAR DOOR is a PURPLE to WHITE (-) Pin A9. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE. to connect. See DIAGRAM NOTE *4 the BCM (Body Control Module) is part of the FUSEBOX under the DRIVERS SIDE of the DASH. NOTE *5 the COLUMN INTEGRATION MODULE is located in the Steering Column.