PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) and RED/WHITE (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	WHITE (+) See NOTE *5	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BROWN (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	GRAY/BLACK (-)	@ BCM, BROWN Plug, Pin B2, See NOTE *1
PARKING LIGHTS ( + )	BROWN (+)	IN DRIVERS KICK PANEL
POWER LOCK	See NOTE *4
POWER UNLOCK	See NOTE *4
DOOR TRIGGER	See NOTE *2
DOMELIGHT SUPERVISION	GRAY/BLACK (-)	@ BCM, BLACK Plug, Pin E, See NOTE *1
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	BLACK (-) or BLACK/YELLOW (-)	@ BCM, GREY Plug, Pin B9, See NOTE *1
TACH	WHITE	@ PCM, See NOTE *3
WAIT TO START LIGHT
BRAKE	LIGHT BLUE (+) or WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN (-)	@ DRIVER DOOR MODULE in DRIVERS DOOR.
ANTI-THEFT	YELLOW (+), ORANGE/BLACK (-) and RED/WHITE (Not used)	GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column.

EXTRA INFORMATION

NOTE *1 the BCM is located UNDER the DRIVER SIDE of the DASH, this unit has 6 Plugs on it, with the PURPLE Plug on the back of the BCM. NOTE *2 This vehicle has (4) door pin trigger wires: DRIVERS door is a GRAY/BLACK (-) at the DRIVERS DOOR MODULE in the drivers door, the PASSENGER DOOR is a BLACK/WHITE (-) in the PASSENGERS DOOR MODULE in the passenger door. For the DRIVERS rear door use a LIGHT BLUE/BLACK (-) Pin A3 and the PASSENGER rear door is a LIGHT GREEN/BLACK (-) Pin A2 both wires are at the BCM's PURPLE plug. When connecting an ALARM SYSTEM use all 4 wires and DIODE ISOLATE. See DIAGRAM NOTE *3 The PCM (Power Control Module) is located under the hood on the left front of engine compartment and to the left of the fan shroud. The TACH wire is in a GREEN Plug, Pin 10. NOTE *4 This vehicle will Requires a Anti-Theft Bypass Module Part GMDL-BP to connect the Door Locks and Bypass the PASSLOCK 2 System. If not connecting up the Door locks use the 791 Bypass module. NOTE *5 IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!!