PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/RED (+) and WHITE/BLUE (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PINK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	YELLOW/GREEN (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	GREEN (-)	@ HEADLIGHT SWITCH
PARKING LIGHTS ( + )	GREEN (+)	@ BACK of FUSEBOX, 12-PIN Plug
POWER LOCK	See NOTE *1	See DIAGRAM
POWER UNLOCK	See NOTE *1	See DIAGRAM
DOOR TRIGGER	See NOTE *3	IN DRIVERS KICK PANEL and PASSENGER KICK PANEL
DOMELIGHT SUPERVISION	TURNS ON with UNLOCK
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	BLACK/YELLOW (-)	@ STEERING COLUMN HARNESS
TACH	YELLOW/GREEN (-)	@ ECM, 31-PIN Plug, Pin 5, See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	GREEN/YELLOW (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire, See NOTE *5	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 THIS VEHICLE WILL REQUIRES AN EXTRA RELAY PART #R30-H AND DIODES TO DO THE KEYLESS ENTRY FUNCTION, to connect, See DIAGRAM NOTE *2 THE BECU (Body Electronic Control Unit) IS LOCATED ABOVE THE DRIVERS KICK PANEL NOTE *3 THE (2) DRIVER SIDE DOOR TRIGGER WIRES ARE IN A 14-PIN PLUG, IN THE DRIVER KICK PANEL. DRIVER DOOR TRIGGER IS GRAY/RED(-) IN PIN 14 , THE DRIVERS REAR DOOR IS RED/WHITE(-) IN PIN 13 . THE (2) PASSENGER SIDE DOOR TRIGGER WIRES ARE IN A 14-PIN PLUG, IN THE PASSENGER KICK PANEL . THE PASSENGER SIDE DOOR, IS A GREEN/BLACK(-) IN PIN 14, AND THE PASSENGER REAR DOOR, IS A RED/WHITE(-) IN PIN 5 . WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL (4) DOOR TRIGGER WIRES AND DIODE ISLOATE, TO CONNECT, SEE DIAGRAM NOTE *4 THE ECM (Engine Control Module) IS LOCATED BEHIND THE GLOVEBOX NOTE *5 THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING.