Vehicle Wiring Details for a
2002 Lincoln Blackwood
Item Wire Color Polarity Wire Location
12V yellow & lt. grn/pur Positive (+) ignition harness
Starter red/lt. blue Positive (+) ignition harness
Starter 2 none
Ignition blue/lt. green Positive (+) ignition harness
2nd Ignition gray/yellow Positive (+) ignition harness
3rd Ignition none
Accessory red/black Positive (+) ignition harness
Accessory 2 black/lt. green Positive (+) ignition harness
Tachometer [6] any ignition coil
Power Door (Lock)
Wiring Diagram for
[Negative (-)] Door Lock
pink/yellow Negative (-) pin 17, 22 pin plug @ CSM [1]
Power Door (Unlock)
Wiring Diagram for
[Negative (-)] Door Unlock
pink/lt. green Negative (-) pin 9, 22 pin plug @ CSM [1]
Door Trigger [2] Negative (-) pins 5-8, upper plug @GEM [3]
Dome Supervision
Wiring Diagram for
[] Dome
use door trigger
Headlights red/yellow Positive (+) headlight switch
Parklight Positive brown Positive (+) headlight switch
Parklight Negative none
Wipers red (L), white (H) Positive (+) windshield wiper motor
Left Front Window
(Up/Down)
wht/blk - org/wht driver window MOTOR
Right Front Window
(Up/Down)
tan/lt blu - wht/yel driver kick panel
Left Rear Window
(Up/Down)
yel/lt blu - gry/org A driver kick panel
Right Rear Window
(Up/Down)
red/blk - yel/blk A driver kick panel
Trunk/Hatch Pin brn/yel & tan [4] Negative (-) tonneau cover control mod [4]
Hood Pin none
Trunk/Hatch Release
Wiring Diagram for
[Negative (-)] Trunk/Hatch
[5] Negative (-) 22 pin plug @ CSM [1]
Factory Alarm
(Arm)
none
Factory Alarm
(Disarm)
none
Horn blue Negative (-) steering column or CSM [1]
Brake lt. green Positive (+) brake pedal switch
Door Motor
(Lock)
pink/black pin 22, 22 pin plug @ CSM [1]
Door Motor
(Unlock)
red/orange pin 1, 26 pin plug @ CSM [1]
Disarm pink/orange pin 11, 22 pin plug @ CSM [1]
Disarm No Unlock none
Additional Info:
Some models ofThis vehicle are equipped with PATS (Passive Anti Theft System). Use Commando module TransMod to over-ride during remote start. [1] The CSM (Central Security Module) is up high in the driver kick panel. [2] The driver door trigger is black/yellow, the front passenger door is black/pink, the left rear door is black/lt. blue, and the right rear door is black/white. Use all four and diode isolate each. Refer to ation or Call Commando Toll-Free at 800.780.1409 for additional wiring information. [3] The GEM (Generic Electronic Module) is attached to the back of the fuse box. [4] These are the door trigger wires for the 2 cargo doors. The tonneau cover control module is on the front passenger side of the cargo bed. [5] Tonneau cover open is white/red in pin 7, and close is pink/lt. green in pin 20. [6] For tach go to any of the ignition coils and use the wire that is NOT red/lt. green.

ATTENTION: This wiring information is being provided free of charge and on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it by using a digital multimeter. GNU Industries, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. GNU assumes no responsibility resulting from an improper installation, even in reliance upon this information.

Copyright © 2000-2006 GNU Industries, Inc. All Rights Reserved.