PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/RED (+) (12 Gauge)	@ IGNITION SWITCH HARNESS PLUG
STARTER	BLACK/WHITE (+) See NOTE *4	@ IGNITION SWITCH HARNESS PLUG
STARTER 2	BLACK/YELLOW (+) (20 Gauge) See NOTE *4	@ IGNITION SWITCH HARNESS PLUG
IGNITION 1	BLACK/RED (+) (14 Gauge)	@ IGNITION SWITCH HARNESS PLUG
IGNITION 2	BLACK/YELLOW (+) (20 Gauge)	@ IGNITION SWITCH HARNESS PLUG
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLUE/RED (+) (18 Gauge)	IGNITION SWITCH HARNESS PLUG
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	BLUE (-) (20 Gauge)	@ BOTTOM of IGNITION SWITCH, in WHITE 2-Pin Plug
PARKING LIGHTS ( - )	RED (-)	@ HEAD LIGHT SWITCH, on Column, WHITE Plug
PARKING LIGHTS ( + )	GREEN (+)	@ BOTTOM WHITE PLUG in FUSEBOX
POWER LOCK	BLUE/YELLOW (Negative (-)) See NOTE *1	IN DRIVERS KICK PANEL, HARNESS from DOOR, BLUE Plug
POWER UNLOCK	BLUE (Negative (-)) See NOTE *1 (Requires Double Pulse)	IN DRIVERS KICK PANEL, HARNESS from DOOR, WHITE Plug
DOOR TRIGGER	See NOTE *2	See DIAGRAM
DOMELIGHT SUPERVISION	TURNS ON with UNLOCK
TRUNK RELEASE	WHITE/BLUE (5-Wire) See NOTE *5,Requires Part #R30-H Relay	IN DRIVERS KICK PANEL
SLIDING POWER DOOR	N/A
HORN	GREEN/BLACK (-)	@ STEERING COLUMN HARNESS
TACH	BLACK/ORANGE	See NOTE *3
WAIT TO START LIGHT	N/A
BRAKE	GREEN/WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with KEYSENSE wire	@ IGNITION SWITCH HARNESS
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 THE LOCK AND UNLOCK WIRES WILL ONLY TEST WHILE TURNING THE KEY IN THE DRIVERS DOOR KEY CYLINDER. NOTE *2 DRIVER DOOR TRIGGER IS RED/GREEN(-) AT LOWER LEFT OF THE FUSEBOX. PASSENGER DOOR TRIGGER IS RED/GREEN(-) AT UPPER LEFT OF THE FUSEBOX. REAR DOOR TRIGGER IS RED/WHITE(-) AT THE BOTTOM OF THE FUSEBOX. WHEN CONNECTING TO AN ALALRM SYSTEM, USE ALL 3 DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM. NOTE *3 ON THE 2.4L ENGINE, THE TACH WIRE IS AT THE DATA LINK CONNECTOR UNDER THE DRIVER SIDE DASH . ON THE 3.0L ENGINE, THE TACH WIRE IS AT THE ECM (Engine Control Module) BEHIND THE GLOVEBOX, IA A 31-PIN PLUG, PIN 5. NOTE *4 this vehicle uses 2 STARTER/CRANK wires, when connecting to a Remote Starter you must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the Remote Starter. NOTE *5 this vehicle uses a 5-Wire TRUNK/HATCH Release System that will require an extra relay part #R30-H, to connect, See DIAGRAM