PART	COLOR	LOCATION
12 VOLT CONSTANT	GREEN (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/RED (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLACK/YELLOW (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	WHITE/BLUE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED/BLUE (+)	IN DRIVERS KICK PANEL, HARNESS to REAR of VEHICLE
POWER LOCK	PINK (Negative (-)) See NOTE *2	IN DRIVERS DOOR or @ BCM, PIN 37, BY FUSEBOX
POWER UNLOCK	BROWN (Negative (-)) See NOTE *2	IN DRIVERS DOOR or @ BCM, PIN 44, BY FUSEBOX
DOOR TRIGGER	See NOTE *3	@ BCM, RIGHT OF THE FUSEBOX
DOMELIGHT SUPERVISION	TURNS ON with UNLOCK
TRUNK RELEASE	RED/BLACK (-) or BLUE/RED (-)	@ BCM, PIN 76, BY FUSEBOX
SLIDING POWER DOOR	N/A
HORN	GREEN/WHITE (-)	@ STEERING COLUMN HANRESS
TACH	WHITE/GREEN	@ ECM, BEHIND GLOVEBOX, See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	RED/GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	WHITE/BLUE (-)	@ DRIVERS SWITCH IN DOOR
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 TEST THESE WIRES WHILE TURNING KEY IN DRIVERS DOOR CYLINDER. NOTE *3 THE LEFT FRONT DOOR TRIGGER IS LIGHT BLUE(-) IN PIN 14. RIGHT FRONT DOOR TRIGGER IS PINK/BLUE(-) IN PIN 10. THE LEFT REAR AND RIGHT REAR IS RED/BLACK(-) IN PIN 11. WHEN CONNECTING TO AN ALARM SYSTEM USE ALL 3 DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM NOTE *4 ON THE 4 CYLINDER ENGINE USE PIN 36. ON 6 CYLINDER ENGINES, USE PIN 34.