PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	RED/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLUE or RED/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	YELLOW/BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	GRAY (+)	@ HEADLIGHT SWITCH See NOTE *2
POWER LOCK	BLUE/WHITE (Negative (-))	@ DRIVERS DOOR MODULE in DRIVERS DOOR
POWER UNLOCK	PURPLE/GREEN (Negative (-)) Requires Double Pulse	@ DRIVERS DOOR MODULE in DRIVERS DOOR
DOOR TRIGGER	USE DOME LIGHT SUPERVISION WIRE
DOMELIGHT SUPERVISION	BROWN/WHITE (-)	@ CCM, Connector 1, Pin 2 See NOTE *3
TRUNK RELEASE	YELLOW/RED (5-Wire) See NOTE *4	@ CCM, Connector 1, Pin 6 See NOTE *3
SLIDING POWER DOOR	N/A
HORN	BLACK/WHITE (+)	IN DRIVERS KICK PANEL, RED 17-Pin Plug
TACH	Any wire NOT RED/BLUE or BLACK/BLUE	@ Any FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	RED/BLACK (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, Single Pulse on UNLOCK wire, Disarms
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 It may be necessary to break the PURPLE wire at the HEADLIGHT switch for the parking lights to turn on. NOTE *3 the CCM Module is mounted on the FLOORPAN in a protective box, under the carpet in front of the DRIVER SEAT. NOTE *4 this vehicle uses a 5-Wire TRUNK/HATCH Release System that will require an extra Relay part #R30-H, to connect, See DIAGRAM