Vehicle
Wiring Details for your
2002 - Cadillac Escalade Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2002 - Cadillac Escalade . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
IGNITION SWITCH HARNESS |
| STARTER |
YELLOW (+) |
IGNITION SWITCH HARNESS |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
IGNITION SWITCH HARNESS |
| IGNITION
2 |
WHITE (+) See NOTE *4 |
IGNITION SWITCH HARNESS |
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
ORANGE (+) |
IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
WHITE (-) |
@ BCM, LIGHT BLUE Plug, Pin A5, See NOTE *1 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
@ BCM, LIGHT BLUE Plug, Pin B6, See NOTE *1 |
| POWER LOCK |
LIGHT BLUE (Positive (+)) |
@ BCM, BROWN PLug, Pin A4, See NOTE *1 |
| POWER UNLOCK |
WHITE (Positive (+)) |
@ BCM, BROWN Plug, Pin A3, See NOTE *1 |
| DOOR TRIGGER |
See NOTE *2 |
@ BCM, See NOTE *1 |
| DOMELIGHT
SUPERVISION |
TAN (-) |
@ BCM, PURPLE Plug, Pin B4, See NOTE *1 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLACK (-) |
@ BCM, BROWN Plug, Pin A9, See NOTE *1 |
| TACH |
WHITE |
@ ECM See NOTE *3 |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
WHITE (+) |
@ SWITCH ABOVE BRAKE PEDAL |
| FACTORY
ALARM DISARM |
LIGHT GREEN (-) |
@ BCM, 24 PURPLE Plug, Pin 3, See NOTE *1 |
| ANTI-THEFT |
YELLOW (+), ORANGE/BLACK (-) and RED/WHITE (Not used) |
GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column. |
| EXTRA
INFORMATION |
| NOTE *1 the BCM is located BEHIND the DRIVERS SIDE of the DASH, with the PLUGS facing the REAR of the vehicle.
NOTE *2 the DRIVERS DOOR is a TAN (-) PURPLE plug, Pin B4, the PASSENGER DOORS is a BLUE/WHITE (-), LIGHT BLUE Plug, Pin B11, when connecting to an ALARM SYSTEM, use both wires and DIODE ISOLATE See DIAGRAM.
NOTE *3 the ECM is located near the battery down low between the fender and the fan under the BLACK plastic cover. On the 4.3L engine the wire is in a 20 Pin connector labled RED and on all other engines the wire is in a 10 Pin RED connector.
NOTE *4 IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!!
|
|
|
|
|
|
