PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	GREEN/RED (+) 20 Gauge wire, 1 of 2, use the one that tests as Ignition	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+) or BLACK/BLUE (+) (Normally not used)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	IN DRIVERS KICK PANEL
POWER LOCK	WHITE/DARK GREEN (1-Wire Door Lock System) See NOTE *1	@ BCM, Connector C4 Pin 15, See NOTE *3
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAM
DOOR TRIGGER	See NOTE *2	@ BCM, See NOTE *3
DOMELIGHT SUPERVISION	YELLOW (-), Requires Part #R30-H Relay	@ FRONT of FUSEBOX, 6-Pin Plug
TRUNK RELEASE	BLACK/WHITE (5-Wire) See NOTE *5, Requires Part #R30-H Relay	@ BCM, Connector C4, Pin 1, See NOTE *3
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
TACH	ANY wire NOT GREEN/LIGHT GREEN	@ COIL PACK
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (+) See NOTE *4	@ BCM, Connector C4, Pin 4, See NOTE *3
ANTI-THEFT	CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 this vehicle uses a 1-Wire Door Locking System, the LOCK requires a (+)Positive thru a 620 Ohm Resistor and the UNLOCK requires a (+)Positive thru a 2700 Ohm Resistor, some units will also require 2 extra relays Part #R30-H, to connect, See DIAGRAM NOTE *2 the DRIVERS DOOR is a TAN (-) Pin 5 the PASSENGER DOOR is a TAN/RED (-) Pin 6 the DRIVERS REAR DOOR is a TAN/ORANGE (-) Pin 7 and the PASSENGER REAR DOOR is a TAN/YELLOW (-) Pin 8 when connecting to an ALARM SYSTEM use all 4 DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DAIGRAM NOTE *3 the BCM (Body Control Module) is attached to FUSE/RELAY BOX located under the drivers side of the dash NOTE *4 the FACTORY DISARM wire requires a (+)Positive thru a 750 ohm Resistor and an extra relay part #R30-H, to connect, See DIAGRAM NOTE *5 the TRUNK RELEASE System on this vehicle is a 5-Wire Positive (+)nd will require an extra Relay part #R30-H, to connect, See DIAGRAM.