NOTE #1: When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2
wires. Both wires must be connected to the STARTER/CRANKING Output wire from the
Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.
NOTE #2: On vehicles with DLR, use the GREEN/GRAY (+) at the HEADLIGHT SWITCH, use a
RELAY to isolate this wire use the DIAGRAM 5-WIRE ISOLATION on the (-) PARKING
LIGHTS INFO. On vehicles without the DRL, use the GREEN/BLACK (+) and
GREEN/RED (+) wires at the HEADLIGHT SWITCH and use the DIAGRAM DAUL
PARKING LIGHT
NOTE #3: THE CENTRAL LOCKING CONTROL MODULE IS UNDER THE DRIVERS SIDE FLOOR MAT
IN FRONT OF THE SEAT.
NOTE #4: DO NOT program in the IGNITION CONTROLLED DOOR LOCKS from the unit, this
may cause problems with the Interior lights in the vehicle.
NOTE #5: DRIVERS DOOR TRIGGER IS GREEN/YELLOW (-) IN CONNECTOR 5 PIN 1 , FRONT
PASSENGER DOOR IS RED/GRAY (-) IN C5 PIN 10 ,LEFT REAR DOOR IS BLACK/RED
(-), IN C5 PIN 12 AND THE RIGHT REAR DOOR IS BLACK/PURPLE (-) IN C5 PIN 14.
NOTE #6: AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass and an extra ignition key for REMOTE STARTING ONLY
to order, go to the SECURITY BYPASS MODULE Page on this website
|