| NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.
NOTE *2 On vehicles with DLR, use the GREEN/GRAY (+) at the HEADLIGHT SWITCH, use a RELAY to isolate this wire use the DIAGRAM 5-WIRE ISOLATION on the (-) PARKING LIGHTS INFO. On vehicles without the DRL, use the GREEN/BLACK (+) and GREEN/RED (+) wires at the HEADLIGHT SWITCH and use the DIAGRAM DAUL PARKING LIGHT
NOTE *3 THE CENTRAL LOCKING CONTROL MODULE IS UNDER THE DRIVERS SIDE FLOOR MAT IN FRONT OF THE SEAT.
NOTE *4 DO NOT program in the IGNITION CONTROLLED DOOR LOCKS from the unit, this may cause problems with the Interior lights in the vehicle.
NOTE *5 DRIVERS DOOR TRIGGER IS GREEN/YELLOW (-) IN CONNECTOR 5 PIN 1 , FRONT PASSENGER DOOR IS RED/GRAY (-) IN C5 PIN 10 ,LEFT REAR DOOR IS BLACK/RED (-) IN C5 PIN 12 AND THE RIGHT REAR DOOR IS BLACK/PURPLE (-) IN C5 PIN 14.
|