NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: This vehicle uses a 1-Wire Door Locking System that requires a (+)Positive thru a
1800 Ohm Resistor to LOCK and a (+)Positive thru a 750 Ohm Resistor to UNLOCK,
some units will also require 2 extra relays part #775, to connect, See DIAGRAM
NOTE #3: The BCM (Body Control Module) is located under the DRIVERS SIDE of DASH and is
attached to the FUSE/RELAY box. Connector 4 is a 26 pin plug at the bottom edge of
the BCM.
NOTE #4: To DISARM requires a (+)Positive thru a 750 Ohm Resistor and an extra Relay part
#775, to connect, See DIAGRAM
NOTE #5: When connecting to an ALARM SYSTEM, use both wires and DIODE ISOLATE,
See DIAGRAM
NOTE #6: the TRUNK/HATCH Release on this vehicle is a 5-Wire System that will require an
extra Relay Part #775 to connect, See DIAGRAM.
|