| NOTE * 1 To Remote Start this vehicle and turn on the AC/Heater, will require an extra relay part #R30-H and a (-)Negative thru a 180 Ohm Resistor, THIS MUST BE INSTALLED to operate in Remote Start mode, to connect, See DIAGRAM.
NOTE * 2 To turn on the PARKING LIGHTS requires a (-)Negative thru a 2000 Ohm resistor and an extra relay part #R30-H to connect, See DIAGRAM
NOTE * 3 This vehicle uses a 1-Wire Door Locking System requiring a (-)Negative thru a 5200 Ohm Resistor for LOCK, and a (-)Negative thru a 2000 Ohm Resistor for UNLOCK, some units will also require 2 extra relays part #R30-H to connect, See DIAGRAMS
NOTE * 4 This vehicle uses 4 door pin trigger wires, the DRIVERS DOOR is a PURPLE (-) at PIN 6, the PASSENGERS DOOR is a PURPLE/WHITE (-) PIN 7, the DRIVERS SIDE SLIDING DOOR is a PURPLE/GREY, PIN 8 and the PASSENGER SIDE SLIDING DOOR is a PURPLE/YELLOW, PIN 5. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE. See DIAGRAM
NOTE * 5 The BCM (Body Control Module is located in the DRIVERS KICK PANEL, near the PARKING BRAKE. The BCM has 5 Plugs, (1) 6-Pin Plug, and (4) 34-Pin PLugs.
NOTE * 6 The Rear Hatch Pop is a (-) Negative thru a 1500 Ohm Resistor and requires an extra relay part #R30-H to connect, See DIAGRAM
NOTE * 7 The SLIDING DOORS require a (-)Negative thru a 1500 Ohm Resistor for the DRIVERS SIDE and a (-)Negative thru a 2700 Ohm Resistor for the PASSANGER SIDE and 2 extra relays part #R30-H for each door, See DIAGRAM.
NOTE * 8 The TACH wire on the 2.4L is BLUE/GREEN or BLUE/TAN. On the 3.3L and 3.8L use the BLUE/GREEN, BLUE/TAN or BLUE/ORANGE
NOTE * 9 This vehicle will DISARM with (-)Negative thru a 9000 Ohm resistor, MUST use SINGLE pulse to DISARM and a DOUBLE pluse on this wire will also UNLOCK.
|
