PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	GREEN/RED (+) 20 Gauge wire	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	IN DRIVERS KICK PANEL or HEADLIGHT SWITCH
POWER LOCK	WHITE/GREEN (1-Wire Door Lock System) See NOTE *1	@ BCM, C4, Pin 15, See NOTE *2
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAM
DOOR TRIGGER	See NOTE *4	@ BCM, See NITE *2
DOMELIGHT SUPERVISION	TAN (-)	@ BCM, Connector 4, Pin 5, See NOTE *2
TRUNK RELEASE	BLACK/WHITE (5-Wire) See NOTE *5	@ BCM, Connector 4, Pin 1, See NOTE *2
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
TACH	ANY wire that is NOT GREEN/LIGHT GREEN	@ Any COIL or FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (+) See NOTE *4	@ BCM, Connector 4, Pin 4, See NOTE *2
ANTI-THEFT	CHRYSLERS SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 This vehicle uses a 1-Wire Door Locking System that requires a (+)Positive thru a 1800 Ohm Resistor to LOCK and a (+)Positive thru a 750 Ohm Resistor to UNLOCK, some units will also require 2 extra relays part #R30-H to connect, See DIAGRAM NOTE *2 The BCM (Body Control Module) is located under the DRIVERS SIDE of DASH and is attached to the FUSE/RELAY box. Connector 4 is a 26 pin plug at the bottom edge of the BCM. NOTE *3 this vehicle uses 4 door pin triggers, at the BCM Connector 4, the DRIVERS DOOR is a TAN (-) Pin 5, the PASSENGERS DOOR is a TAN/RED (-) Pin 6, the DRIVERS REAR DOOR is a TAN/ORANGE (-) Pin 7 and the PASSENGER REAR DOOR is a TAN/YELLOW, Pin 8. When connecting to an alarm system use all 4 wires and DIODE ISOLATE, See DIAGRAM. NOTE *4 To DISARM requires a (+)Positive thru a 750 Ohm Resistor and an extra Relay part #R30-H, to connect, See DIAGRAM NOTE *5 the TRUNK/HATCH Release on this vehicle is a 5-Wire System and will require an extra Relay Part #R30-H, to connect, See DIAGRAM.