PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	LIGHT BLUE (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	@ HEADLIGHT SWITCH
POWER LOCK	WHITE/GREEN (1-Wire Door Lock System) See NOTE *1	IN DRIVERS KICK PANEL, AT DOOR HARNESS See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAM
DOOR TRIGGER	See NOTE *2	IN EACH KICK PANEL, See DIAGRAM
DOMELIGHT SUPERVISION	TAN (-) or TAN/BLUE (-), Requires #R30-H Relay	IN DRIVERS KICK PANEL
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
TACH	BLACK/GRAY	@ IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK
ANTI-THEFT	CHRYSLERS SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 This vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a 3000 Ohm Resistor and UNLOCK, requires a (-)Negative thru a 7200 Ohm Resistor, and requires a DOUBLE PULSE to UNLOCK. Some unit also require 2 extra relays Part #R30-H, to connect, See DIAGRAM NOTE *2 This vehicle has 2 Door Trigger wires a TAN (-) or TAN/BLUE (-) in the DRIVERS KICK PANEL for the DRIVERS DOOR and a BLUE/ORANGE (-) in the PASSENGERS KICK PANEL is for all other doors. When using an ALARM SYSTEM use both wires and DIODE ISOLATE. See DIAGRAM