| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: the LOCK and UNLOCK wires are DOOR KEY CYLINDER wires. TEST these wires while
TRUNING THE KEY in the DRIVERS DOOR KEY CYLINDER. UNLOCK requires a DOUBLE
PULSE. On vehicles with the FACTORY ALARM, use the PURPLE (-) for LOCK and
LIGHT GREEN/RED (-) for UNLOCK, these wires are at the DRIVERS DOOR LOCK
SWITCH.
NOTE #3: Wires are located in a BLACK 19-pin plug, on the back of the FUSEBOX under the
drivers side of dash.
NOTE #4: this wire is located in the plug on the upper RIGHT side of the FUSEBOX under the
DRIVER side of DASH.
NOTE #5: this vehicle uses a 5-Wire TRUNK RELEASE System and will require an extra relay
part #775, to connect, See DIAGRAM.
NOTE #6: go to the TEST CONNECTOR inside the fusebox under the hood, it is the T-Shaped
plug, on the top left of the plug, the wire UNDER the terminal is WHITE or WHITE/RED
|
