PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/RED (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLUE/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	GREEN/WHITE (+) or PINK/BLACK (+)	LOW in DRIVERS KICK PANEL
POWER LOCK	LIGHT GREEN/BLACK (Negative (-)) See NOTE *1	IN DRIVERS KICK PANEL
POWER UNLOCK	ORANGE (Negative (-)) See NOTE *1	IN DRIVERS KICK PANEL
DOOR TRIGGER	GREEN/YELLOW (-)	@ FUSEBOX, See NOTE *2
DOMELIGHT SUPERVISION	GREEN/ORANGE (-), Requires Part #R30-H Relay	@ FUSEBOX, See NOTE *3
TRUNK RELEASE	GREEN/WHITE (5-Wire) See NOTE *4, Requires Part #R30-H Relay	IN DRIVERS KICK PANEL
SLIDING POWER DOOR	N/A
HORN	LIGHT GREEN/BLACK (-)	@ STEERING COLUMN HARNESS
TACH	See NOTE *5	@ TEST CONNECTOR
WAIT TO START LIGHT	N/A
BRAKE	GREEN/ORANGE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK
ANTI-THEFT	CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the LOCK and UNLOCK wires are DOOR KEY CYLINDER wires. TEST these wires while TRUNING THE KEY in the DRIVERS DOOR KEY CYLINDER. UNLOCK requires a DOUBLE PULSE. On vehicles with the FACTORY ALARM, use the PURPLE (-) for LOCK and LIGHT GREEN/RED (-) for UNLOCK, these wires are at the DRIVERS DOOR LOCK SWITCH. NOTE *2 Wires are located in a BLACK 19-pin plug, on the back of the FUSEBOX under the drivers side of dash. NOTE *3 this wire is located in the plug on the upper RIGHT side of the FUSEBOX under the DRIVER side of DASH. NOTE *4 this vehicle uses a 5-Wire TRUNK RELEASE System and will require an extra relay part #R30-H, to connect, See DIAGRAM. NOTE *5 go to the TEST CONNECTOR inside the fusebox under the hood, it is the T-Shaped plug, on the top left of the plug, the wire UNDER the terminal is WHITE or WHITE/RED