PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/RED (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLUE/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	GREEN/WHITE (+) or PINK/BLACK (+)	LOW in DRIVERS KICK PANEL
POWER LOCK	LIGHT GREEN/BLACK (Negative (-)) See NOTE *1	IN DRIVERS KICK PANEL
POWER UNLOCK	ORANGE (Negative (-)) See NOTE *1	IN DRIVERS KICK PANEL
DOOR TRIGGER	GREEN/YELLOW (-)	@ FUSEBOX, on BACK SIDE, in BLACK 19 Pin Plug
DOMELIGHT SUPERVISION	GREEN/ORANGE (-), Requires #R30-H Relay	@ FUSE BOX, in WHITE 43 Pin Plug
TRUNK RELEASE	GREEN/WHITE (5-Wire) See NOTE *3	IN DRIVERS KICK PANEL, 43 Pin Plug
SLIDING POWER DOOR	N/A
HORN	LIGHT GREEN/BLACK (-)	@ STEERING COLUMN HARNESS
TACH	WHITE or WHITE/RED	See NOTE *2
WAIT TO START LIGHT	N/A
BRAKE	GREEN/ORANGE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, SINGLE PULSE
ANTI-THEFT	CHRYSLERS SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 These are the DOOR LOCK key cylinder wires. Test these wires when turning the key in the drivers door key cylinder. UNLOCK on this vehicle requires a DOULBE PULS UNLOCK. On vehicle without a FACTORY ALARM SYSTEM, the LOCK is a PURPLE (Negative (-)) and the UNLOCK is a GREEN/RED (Negative (-)) these are the DOOR LOCK SWITCH wires located in a BLACK 32 Pin plug. NOTE *2 The TACH wire is at the TEST CONNECTOR in the FUSEBOX under the hood. It is a "T" SHAPED PLUG. The TACH wire is the terminal on the TOP LEFT of the "T". Under the connector at this terminal you will find a WHITE or WHITE/RED wire. NOTE *3 the TRUNK/HATCH Release System on this vehicle uses a 5-Wire Circuit and will require an extra Relay part #R30-H, to connect, See DIAGRAM.