PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED/YELLOW (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	RED/WHITE (+) (Small Gauge wire)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A	IGNITION SWITCH HARNESS
KEYSENSE	LIGHT BLUE (-)	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	LIGHT GREEN/RED (-)	@ HEADLIGHT SWITCH
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	@ BLUE, 22Pin Plug above BRAKE
POWER LOCK	ORANGE/VIOLET (Positive (+))	@ BCM, Connector 2, Pin 41, See NOTE *1
POWER UNLOCK	PINK/VIOLET (Positive (+))	@ BCM, Connector 2, Pin 75, See NOTE *1
DOOR TRIGGER	TAN (-) and TAN/RED (-) use both, See NOTE *4	@ BCM, C2, Pins 79 and 48, See NOTE *1
DOMELIGHT SUPERVISION	TAN (-)	@ BCM, C2, Pin 48, See NOTE *1
TRUNK RELEASE	YELLOW/RED (+) See NOTE *2	@ RELAY BEHIND GLOVEBOX
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ BCM, C1, Pin 17, See NOTE *1
TACH	GRAY/LIGHT BLUE	@ TACH on COLUMN, Pin 1
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ STEERING COLUMN HARNESS
FACTORY ALARM DISARM	LIGHT GREEN/BLACK (-) See NOTE *3	@ BCM. C2, Pin 45, See NOTE *1
ANTI-THEFT	CHRYSLERS SENTRY KEY (GRAY KEY ONLY)	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the BCM (Body Control Module) is located in the DRIVERS KICK PANEL. Connector 1 is WHITE, and on TOP with plug towards the FRONT of the vehicle, Connector 2 is WHITE, and on TOP with plug towards the REAR of vehicle. Connector 3 is BLACK and at the BOTTOM. NOTE *2 CAUTION!!!! The REAR of the CONVERTIBLE TOP must be UNLATCHED and FOLDED forward BEFORE using the TRUNK RELEASE. NOTE *3 A (-) Negative thru a 663 Ohm Resistor will DISARM the Factory Security without UNLOCKING the doors. NOTE *4 When connecting to an ALARM SYSTEM use both wires and DIODE ISOLATE, to connect, See DIAGRAM