PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	GRAY/BLACK (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	GREEN/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	YELLOW (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	ORANGE/YELLOW (+)	@ HEADLIGHT SWITCH
POWER LOCK	BLACK/RED (Negative (-))	IN DRIVERS KICK PANEL
POWER UNLOCK	BLACK/YELLOW (Negative (-))	IN DRIVERS KICK PANEL
DOOR TRIGGER	BLACK/YELLOW (-) and BLACK/BLUE (-) use Both, See NOTE *1	LOW IN DRIVERS KICK PANEL, See NOTE *1
DOMELIGHT SUPERVISION	USE DOOR TRIGGER, Requires Part #R30-H Relay
TRUNK RELEASE	BLACK/YELLOW (-), Requires Part #R30-H Relay	@ TRUNK RELEASE SWITCH or KEYLESS ENTRY MODULE, See NOTE *3
SLIDING POWER DOOR	N/A
HORN	BLACK/BLUE (-)	@ STEERING COLUMN HARNESS
TACH	BLACK/GREEN	@ IGNITON COIL
WAIT TO START LIGHT	N/A
BRAKE	LIGHT GREEN/RED (+)	@ SWITCH ABOVE BRAKE PEDAL See NOTE *2
FACTORY ALARM DISARM	N/A
ANTI-THEFT	FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 This vehicle has (2) door trigger wires, when connecting to an ALARM SYSTEM, use both wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *2 The IGNITION SWITCH MUST be turned on before the Brake wire will test properly. NOTE *3 The FACTORY KEYLESS ENTRY Module (if so equipped) is located behind and to the right of the GLOVE BOX.