| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
NOTE #2: this vehicle uses a 1-Wire Door Locking system, if vehicle is WITHOUT a FACTORY
ALARM SYSTEM, LOCK requires a (-)Negative thru a 1000 Ohm Resistor and UNLOCK
is a (-)Negative thru a 250 Ohm Resistor. If vehicle HAS a FACTORY ALARM SYSTEM,
ARM/LOCK is a (-)Negative thru a 2700 Ohm Resistor and DISARM/UNLOCK is a
(-)Negative thru a 7500 Ohm Resistor, some units will require 2 extra relays part
#775, to connect, See DIAGRAM.
NOTE #3: the TRUNK RELEASE on the vehicle uses a 5-Wire Circuit and will require an extra
Relay part # 775 to connect, See DIAGRAM.
NOTE #4: the KEYLESS ENTRY Module located in the Center TOP of DASH, remove the dash top
to access the Keyless Entry Module.