Vehicle
Wiring Details for your
2000-2002 Chevrolet Tahoe Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2000-2002 Chevrolet Tahoe . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ IGNITION SWITCH HARNESS |
| STARTER |
YELLOW (+) |
@ IGNITION SWITCH HARNESS |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH HARNESS |
| IGNITION
2 |
WHITE (+), SEE NOTE #2 |
@ IGNITION SWITCH HARNESS |
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
ORANGE (+) |
@ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER
BLOWER 2 |
BROWN (+) |
@ IGNITION SWITCH HARNESS |
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
WHITE (-) |
@ BCM, LT. BLUE PLUG, PIN A5, SEE NOTE #3 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
@ BCM, LT. BLUE PLUG, PIN B6, SEE NOTE #3 |
| POWER LOCK |
LT. BLUE (TYPE A) |
@ BCM, BROWN PLUG, PIN A4, SEE NOTE #3 |
| POWER UNLOCK |
WHITE (TYPE A) |
@ BCM, BROWN PLUG, PIN A3, SEE NOTE #3 |
| DOOR TRIGGER |
TAN (-) |
@ BCM, PURPLE PLUG, PIN B4, SEE NOTE #3 |
| DOMELIGHT
SUPERVISION |
GRAY/BLACK (-) |
@ BCM, LT. BLUE PLUG, PIN A3, SEE NOTE #3 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLACK (-) |
@ BCM, BROWN PLUG, PIN A9, SEE NOTE #3 |
| TACH |
WHITE (AC) |
@ ECM, SEE NOTE #4 |
| WAIT TO
START LIGHT |
DK. BLUE (-) |
@ INSTRUMENT CLUSTER |
| BRAKE |
WHITE (+) |
@ SWITCH ABOVE BRAKE PEDAL |
| FACTORY
ALARM DISARM |
LT. GREEN (-) |
@ BCM, PURPLE PLUG, PIN B3, SEE NOTE #3 |
| ANTI-THEFT |
GM'S PASSLOCK 2 ANTI-THEFT SYSTEM, SEE NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle is equipped with the PASSLOCK 2 ANTI-THEFT SYSTEM and will require a
791 Bypass Module for Remote Starting,
to order go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: The IGNITION #2 wire WHITE must be connected to prevent a CHECK ENGINE LIGHT
from turning on and to prevent DAMAGE to the TRANSMISSION on this Vehicle.
NOTE #3: The BCM is located BEHIND the DRIVERS SIDE of the DASH, with the Plugs facing
towards the REAR of the Vehicle.
NOTE #4: The ECM is located NEAR the Battery, down low, between the Fender and the fan
under a Black Plastic cover. The tach wire on the 4.3L Engine is in Pin 20 in a
connector labled RED. On the 4.8L, 5.3L and 6.0L Engines, the tach wire is in the
RED connector pin 10.
|
|
|
|
|
|
