NOTE #1: When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2
wires. Both wires must be connected to the STARTER/CRANKING Output wire from the
Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.
NOTE #2: the PARKING LIGHT Circuit on this vehicle uses 2 wires, to connect this circuit will
requires 2 extra Relays Part #775, to connect, See DIAGRAM
NOTE #3: USE BROWN/YELLOW (-) OR GREEN/YELLOW (-) IN A BROWN 10-PIN CONNECTOR IN
THE DRIVERS KICK FOR THE DRIVERS DOOR TRIGGER AND BROWN/WHITE (-) OR
GREEN /YELLOW (-) IN A BROWN 10 PIN CONNECTOR IN THE PASSENGERS KICK FOR
THE PASSENGER DOOR TRIGGER . WHEN CONNECTING TO AN ALARM SYSTEM USE
BOTH WIRES AND DIODE ISOLATE, See DIAGRAM
NOTE #4: the TRUNK/HATCH Release System on this vehicle uses a 5-Wire Circuit, to connect
will require an exra Relay Part #775, See DIAGRAM.
NOTE #5: AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass and an extra ignition key for REMOTE STARTING ONLY
to order, go to the SECURITY BYPASS MODULE Page on this website
|