PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW(+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK(+)	IGNITION SWITCH HARNESS
IGNITION 2	GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	LIGHT GREEN (-) See NOTE *1	IGNITION SWITCH HARNESS
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ STEERING COLUMN HARNESS
POWER LOCK	ORANGE/BLACK (Positive (+))	IN DRIVERS KICK PANEL
POWER UNLOCK	RED/BLACK (Positive (+))	IN DRIVERS KICK PANEL
DOOR TRIGGER	See NOTE *2	@ BCM, See NOTE *4
DOMELIGHT SUPERVISION	GRAY/BLACK (-)	@ BCM, See NOTE *4
TRUNK RELEASE	BLACK (+), Requires Part #R30-H Relay	@ TRUNK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ STEERING COLUMN HARNESS
TACH	See NOTE *3
WAIT TO START LIGHT	N/A
BRAKE	LIGHT BLUE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	YELLOW (+) and BLACK (-) and WHITE (Not Used)	GM's PASSLOCK 2 System, wires are under the Steering Column cover, at the Bottom of the Ignition Switch Tumbler in a BLACK or DARK GRAY Plug

EXTRA INFORMATION

NOTE *1 THE LIGHT GREEN (-) KEY SENSE WIRE AT THE STEERING COLUMN, MUST SEE A (-)NEGATIVE DURING REMOTE START TO KEEP THE SERVICE ENGINE LIGHT FROM COMING ON. NOTE *2 THE DRIVERS DOOR IS GRAY/BLACK (-).THE OTHER DOORS ARE BLACK/WHITE (-). BOTH WIRES ARE IN THE GRAY 24-PIN PLUG AT THE BCM. WHEN CONNECTING TO AN ALARM SYSTEM, USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM NOTE *3 ON THE 4 CYLINDER MODELS USE PURPLE/WHITE AT THE IGNITION MODULE ON THE DRIVERS SIDE OF THE MOTOR. ON THE 6 CYLINDER MODELS AT THE IGNITION COILS ON TOP OF THE CYLINDER HEAD ON THE DRIVERS SIDE OF THE MOTOR, USE ANY 1 OF THE 3 WIRES THAT IS NOT PINK OR BLACK. NOTE *4 THE BCM (Body Control Module) IS LOCATED ABOVE THE GLOVE BOX.