PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	@ STEERING COLUMN HARNESS
POWER LOCK	LIGHT GREEN (1-Wire Door Lock System) See NOTE *1	@ DRIVERS DOOR HARNESS, See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	YELLOW (-)	IN DRIVERS KICK PANEL
DOMELIGHT SUPERVISION	USE DOOR TRIGGER, Requires #R30-H Relay
TRUNK RELEASE	LIGHT GREEN/BLACK (5-Wire) See NOTE *2, Requires #R30-H Relay	@ KEYLESS ENTRY MODULE, See NOTE *3
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
TACH	BLACK/GRAY	@ COIL PACK
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK
ANTI-THEFT	CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 this vehicle uses a 1-Wire Door Locking system, if vehicle is WITHOUT a FACTORY ALARM SYSTEM, LOCK requires a (-)Negative thru a 1000 Ohm Resistor and UNLOCK is a (-)Negative thru a 250 Ohm Resistor. If vehicle HAS a FACTORY ALARM SYSTEM, ARM/LOCK is a (-)Negative thru a 2700 Ohm Resistor and DISARM/UNLOCK is a (-)Negative thru a 7500 Ohm Resistor, some units will require 2 extra relays part #R30-H, to connect, See DIAGRAM. NOTE *2 the TRUNK RELEASE on the vehicle uses a 5-Wire Circuit and will require an extra Relay part # R30-H to connect, See DIAGRAM. NOTE *3 the KEYLESS ENTRY Module located in the Center TOP of DASH, remove the dash top to access the Keyless Entry Module.