PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	RED/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLUE or RED/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	YELLOW/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	GRAY/BROWN (+) and GRAY/PURPLE (+) Must use both See NOTE *2	@ HEADLIGHT SWITCH See DIAGRAM
POWER LOCK	PURPLE/GRAY (Negative (-))	IN DRIVERS KICK PANEL, BROWN 10-PIN Plug
POWER UNLOCK	RED/GRAY (Negative (-))	IN DRIVERS KICK PANEL, BROWN 10-PIN Plug
DOOR TRIGGER	SEE NOTE *3	IN BROWN 10-PIN PLUG, BOTH KICK PANELS
DOMELIGHT SUPERVISION	USE DOOR TRIGGER
TRUNK RELEASE	PURPLE/GREEN (5-Wire) See NOTE *4	@ HATCH RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK/YELLOW (+)	@ HORN
TACH	GREEN/BROWN	@ ECM HOUSING, ORANGE 10-PIN PLUG
WAIT TO START LIGHT	N/A
BRAKE	RED/BLACK (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 the PARKING LIGHT Circuit on this vehicle uses 2 wires, to connect this circuit will requires 2 extra Relays Part #R30-H, to connect, See DIAGRAM NOTE *3 USE BROWN/YELLOW (-) OR GREEN/YELLOW (-) IN A BROWN 10-PIN CONNECTOR IN THE DRIVERS KICK FOR THE DRIVERS DOOR TRIGGER AND BROWN/WHITE (-) OR GREEN /YELLOW (-) IN A BROWN 10 PIN CONNECTOR IN THE PASSENGERS KICK FOR THE PASSENGER DOOR TRIGGER . WHEN CONNECTING TO AN ALARM SYSTEM USE BOTH WIRES AND DIODE ISOLATE, See DIAGRAM NOTE *4 the TRUNK/HATCH Release System on this vehicle uses a 5-Wire Circuit, to connect will require an exra Relay Part #R30-H, See DIAGRAM.