PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) and RED/WHITE (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	WHITE (+) See NOTE *6	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BROWN/WHITE (-)	@ BCM, BLUE PLUG, PIN D11, See NOTE *1
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT SWITCH or in DRIVERS KICK PANEL
POWER LOCK	RED/BLACK (TYPE B) See NOTE *5	@ BCM, See NOTE *1
POWER UNLOCK	ORANGE/BLACK (TYPE B) See NOTE *5	@ BCM, See NOTE *1
DOOR TRIGGER	See NOTE *2	@ BCM, See NOTE *1
DOMELIGHT SUPERVISION	GRAY/BLACK (-)	@ BCM, NEUTRAL Plug Pin F, See NOTE *1
TRUNK RELEASE	N/A
SLIDING POWER DOOR	LIGHT BLUE (-) and LIGHT BLUE/BLACK See NOTE *3	IN EACH KICK PANEL
HORN	BLACK (-)	@ BCM, See NOTE *1
TACH	PURPLE/WHITE	@ IGNITION COILS on ENGINE
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK
ANTI-THEFT	GM's PASSKEY 3 (PK3 on Steel Shaft of Ignition Key) TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 The BCM (Body Control Module) is located ABOVE the PASSENGER SIDE KICK PANEL. NOTE *2 This vehicle has (3) door trigger wires. The DRIVERS DOOR is a TAN (-), PASSENGER DOOR and LIFT GATE is a DARK BLUE (-) and ORANGE (-) for the SLIDING DOOR(S). When connecting to an ALARM SYSTEM use all 3 wires and DIODE ISOLATE. See DIAGRAM NOTE *3 A pulse of (-)Negative to this LIGHT BLUE (-) RIGHT DOOR and the LIGHT BLUE/BLACK (-) LEFT DOOR wire will OPEN the power sliding door and a pulse of (-)Negative on the same wire will then CLOSE the power sliding door. NOTE *4 The TACH wire is in the MAIN HARNESS on the DRIVERS SIDE of the ENGINE, ON TOP of the Manifold Cover. NOTE *5 If vehicle does not have FACTORY ALARM, use a LIGHT BLUE (-) for LOCK, and WHITE (-) for UNLOCK these wires are located in either kick panel. If vehicle is equipped with a FACTORY ALARM use the RED/BLACK (-) for LOCK and the ORANGE/BLACK (-) these wires will only meter when turning the key in either door key cylinder. You must also program the units door lock pulse length to 3.5 second pulse. NOTE *6 IMPORTANT !!!!! this wire MUST BE CONNECTED for REMOTE STARTING!!!!!!