PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/RED (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLUE (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	YELLOW/BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	GREEN/BLACK (+) and GREEN/RED (+) Use both See NOTE *2	@ HEADLIGHT SWITCH See DIAGRAM
POWER LOCK	BROWN/RED (Negative (-))	IN DRIVERS KICK PANEL, at DOOR HARNESS
POWER UNLOCK	BROWN/YELLOW (Negative (-)) Requires Double Pulse	IN DRIVERS KICK PANEL, at DOOR HARNESS
DOOR TRIGGER	SEE NOTE *3	@ INSTRUMENT CLUSTER, GRAY PLUG
DOMELIGHT SUPERVISION	COMES ON WITH UNLOCK
TRUNK RELEASE	RED/BROWN (+)	@ TRUNK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK/GREEN (+)	@ FUSEBOX or HORN RELAY
TACH	Any wire NOT BLACK/YELLOW, BROWN or BROWN/BLACK	@ Any IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	RED/BLACK (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, Single Pulse on UNLOCK wire, Disarms
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 the PARKING LIGHT Circuit on this vehicle uses 2 wires, to connect this circuit will requires 2 extra Relays Part #R30-H, to connect, See DIAGRAM NOTE *3 DRIVERS DOOR TRIGGER IS GREEN/YELLOW(-) IN CONNECTOR 5 PIN 1 , FRONT PASSENGER DOOR IS RED/GRAY(-) IN C5 PIN 10 , LEFT REAR DOOR IS BLACK/RED(-) IN C5 PIN 12 AND THE RIGHT REAR DOOR IS BLACK/PURPLE(-) IN C5 PIN 14. WHEN CONNECTING TO AN ALARM SYSTEM USE ALL 4 WIRES AND DIODE ISOLATE, See DIAGRAM