PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	GRAY/WHITE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	YELLOW (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BLACK/YELLOW (-)	@ KEYLESS ENTRY MODULE, See NOTE *1
PARKING LIGHTS ( + )	RED/BLUE (+) and RED/YELLOW (+) Use both, See NOTE *2	@ HEADLIGHT SWITCH, See DIAGRAM
POWER LOCK	YELLOW/GREEN (Negative (-))	IN DRIVERS KICK PANEL
POWER UNLOCK	WHITE/GREEN (Negative (-))	IN DRIVERS KICK PANEL
DOOR TRIGGER	BLACK/RED (-) and BLACK/GREEN (-) Use both, See NOTE *3	@ TOP of FUSEBOX
DOMELIGHT SUPERVISION	BLACK/BLUE (-), Requires Part #R30-H Relay	@ DRIVER A PILLAR
TRUNK RELEASE	BLACK/YELLOW (-), Requires Part #R30-H Relay	@ TRUNK RELEASE SWITCH or in DRIVERS KICK PANEL
SLIDING POWER DOOR	N/A
HORN	BLACK/BLUE (-)	@ STEERING COLUMN HARNESS
TACH	BROWN/GREEN	@ IGNITION COIL PACK
WAIT TO START LIGHT	N/A
BRAKE	ORANGE/BLUE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	BLACK/WHITE (-)	IN DRIVERS KICK PANEL
ANTI-THEFT	FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the FACTORY KEYLESS ENTRY Module is located behind the GLOVE BOX, this wire flashes the hazard lights. NOTE *2 these wires must be isolated with 2 relay part #R30-H, so that the headlights do not operate with the parking lights. See DIAGRAM. NOTE *3 the BLACK/RED (-) is for the drivers door, and the BLACK/GREEN (-) is for the passenger door, when connecting to an ALARM SYSTEM us both wires and DIODE ISOLATE. For Dome Light Supervision use the BLACK/RED (-) is for the drivers door. To get to these wires, pull the fuse panel down and remove the cover.