NOTE #1: This vehicle uses GM'S PASSLOCK 2 ANTI-THEFT SYSTEM that requires a 791 Bypass
Module to Remote Start, to order go to the SECURITY BYPASS MODULES Page on this
website.
NOTE #2: if vehicle is a 2-Door it is a TYPE C door lock system, if vehicle is a 4-Door or if it
has a FACTORY KEYLESS ENTRY System it is a TYPE A door lock system.
NOTE #3: At the BCM the DRIVER DOOR is a TAN (-) Pin B4 of the PURPLE PLUG, the
PASSENGER DOOR is a ORANGE (-) Pin B2. When connecting to an alarm system
use both wires and DIODE ISOLATE. See DIAGRAM
NOTE #4; the ECM is located on the DRIVERS SIDE inner fender, with 2 plugs, look for the
WHITE wire in the plug labled "WHITE"
NOTE #5: THE DIESEL TACH wire is also a WHITE but at the Instrument cluster.
NOTE #6; when hooking up a remote starter, if you cannot get the (+) or (-) Wait to Start wire
on the Remote Starter to work properly, you will then need to disconnect this wire
and Program the Remote Starter for the 5, 10, 15 or 20 Second Wait to Start Timmer
in the Installation manual.
NOTE #7; IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for
REMOTE STARTING!!!!!!
|